its TEQ Diffused Flexible Light
Specifications
- Part Numbers: TEQ, TBQ, TPB, TPC, TPD, TPE, TPQ, TSB, TSQ, RBLL, RELL, RHLL & RSLL
- Power Supply: UL Recognized (purchased separately)
- Mounting Channel: Purchased separately
FAQs
- Q: Can I field-cut the flexible light?
- A: No, field-cutting the light will void the warranty.
- Q: What should I use to clean the surface before installation?
- A: Clean the surface with a mixture of 50% water/50% isopropyl alcohol and let it dry.
- Q: Can I install the flexible light on rough plywood or edges?
- A: It is recommended to use mounting channels TPB-1 or TPB-2 instead of installing on rough surfaces.
PARTS TOOLS NEEDED
Part#: TEQ, TBQ, TPB, TPC, TPD, TPE, TPQ, TSB, TSQ, RBLL, RELL, RHLL & RSLL
IMPORTANT SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding, or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Use only with a UL-approved power supply.
- The addressable flex light is NOT polarity protected. Wiring the light incorrectly could cause damage.
INSTALLATION CONSIDERATIONS
- It is recommended that fuse protection be added to the positive (+) input.
- Do not bend lighting more than necessary. It should only be bent to a 1” radius. Bending to a tight 90° angle could cause damage to the circuit.
- Only bend the LED ribbon in one natural direction, do not try to bend it in an unnatural direction such as twisting.
- Make sure surfaces are smooth, clean, and free of dust and debris before installing this product. Surfaces should be cleaned and primed per the 3M specified cleaning instructions* on page two. Failure to properly clean the surface may result in loss of adhesion.
- Rough surfaces may prevent proper adhesion. If adhesion failure occurs, screw-in mounting channels may be used for installation. Contact ITC sales for more information on mounting channels: 616-396-1355 / sales@itc-us.com.
INSTALLATION INSTRUCTIONS
- Clean the surface with a mixture of 50% water/50% isopropyl alcohol. Let the surface dry.
- Apply Primer 94 as recommended by 3M. Failure to follow the surface preparation guidelines will void the warranty.
- Remove the paper backing and firmly press the light in place. DO NOT slide or drag your thumb along the tape light or the silicone may be pulled off.
- If using mounting channels for installation, they are available in screw or adhesive mount. Install per your desired method.
- Screw Mount Channel: Screws should be used every 12”.
- Adhesive Mount Channel: Follow the same cleaning instructions above remove paper backing from the channel and press in place.
- Both Channels: Remove the paper backing from the light and press the light into the channel.
- Wire the light based on the wiring diagrams below.
- Please review the considerations below to ensure a successful installation.
- Flexible light cannot be field cut. Field cutting the light will void the warranty.
- Flexible light cannot be field cut. Field cutting the light will void the warranty.
CONTACT INFORMATION
- 3030 Corporate Grove Dr.
- Hudsonville, MI 49426
- Phone: 616.396.1355
- itc-us.com.
- For warranty information please visit www.itc-us.com/warranty-return-policy
- DOC #: 710-00127
- Rev H 06/03/24
Documents / Resources
 |
its TEQ Diffused Flexible Light [pdf] Installation Guide TEQ Diffused Flexible Light, TEQ, Diffused Flexible Light, Flexible Light, Light |
