Prodotto finitoview
This document provides instructions for the proper installation, maintenance, and care of the Royal Dirt Devil Foam Filter, part number #1KQ0106000 (also known as RO-KQ0106). This genuine replacement foam filter is designed for use with specific Dirt Devil canister vacuum models, including the SD4000 Canister Vac, SD40000 Vision Pet Canister Vac, and SD40010 EZ Lite Canister Vac. Regular filter maintenance is crucial for maintaining optimal vacuum performance and air quality.
Image of the Royal Dirt Devil Foam Filter, part number #1KQ0106000, designed for specific Dirt Devil canister vacuum models.
Configurazione e installazione
- Spegnere e scollegare: Before attempting any installation or maintenance, ensure your Dirt Devil vacuum cleaner is turned off and unplugged from the electrical outlet. This prevents accidental startup and potential injury.
- Individuare il vano filtro: Refer to your vacuum cleaner's original user manual to locate the foam filter compartment. This is typically found near the dustbin or motor housing.
- Rimuovi il vecchio filtro: Carefully open the filter compartment and remove the old, dirty foam filter. Dispose of the old filter responsibly.
- Inserisci nuovo filtro: Place the new Royal Dirt Devil Foam Filter (#1KQ0106000) into the designated compartment. Ensure it is seated correctly and securely to create a proper seal. An improper fit can lead to reduced suction and dust leakage.
- Chiudi scomparto: Close the filter compartment securely. Ensure all latches or covers are properly fastened.
- Prova del vuoto: Collega l'aspirapolvere ed esegui un breve test per verificare che funzioni normalmente e che l'aspirazione sia ripristinata.
Considerazioni operative
Once installed, the foam filter works continuously to capture dust and debris during vacuum operation. For optimal performance:
- Ensure the filter is always clean and dry before each use.
- Avoid vacuuming liquids or excessively wet debris, as this can damage the foam filter and the vacuum motor.
- If you notice a significant decrease in suction power, check the filter for excessive dirt or blockages.
Manutenzione
Regular cleaning and timely replacement of the foam filter are essential for maintaining your vacuum's efficiency and extending its lifespan.
Pulizia del filtro in schiuma:
- Rimuovi filtro: Turn off and unplug the vacuum. Remove the foam filter as described in the "Setup and Installation" section.
- Risciacquo: Rinse the foam filter under cool, running water until the water runs clear. Gently squeeze the filter to remove excess water and dislodge trapped dirt. Do not twist or wring forcefully, as this can damage the foam.
- Asciugare completamente: Allow the filter to air dry completely for at least 24 hours before reinstallation. Do not use a dryer or any heat source, as this can deform or damage the foam. Ensure the filter is absolutely dry to prevent mold growth and damage to the vacuum motor.
- Reinstalla: Once completely dry, reinstall the filter into your vacuum cleaner.
Nota: The frequency of cleaning depends on usage. For average household use, cleaning every 1-3 months is recommended.
Sostituzione del filtro:
It is recommended to replace the foam filter every 6-12 months, or sooner if you notice signs of wear, tear, or if cleaning no longer restores its original performance. A worn-out filter can compromise suction and air filtration.
Risoluzione dei problemi
| Problema | Possibile causa | Soluzione |
|---|---|---|
| Potenza di aspirazione ridotta | Clogged or dirty foam filter. | Clean the foam filter thoroughly. Ensure it is completely dry before reinstallation. If suction does not improve, consider replacing the filter. |
| Aspirapolvere per la fuoriuscita di polvere | Filter not properly seated or damaged. | Check that the filter is correctly installed and the compartment is securely closed. Inspect the filter for any tears or damage; replace if necessary. |
| Odore insolito dall'aspirapolvere | Damp or moldy filter. | Ensure the filter is completely dry after cleaning. If odor persists, replace the filter. |
Specifiche
- Numero parte: #1KQ0106000 (RO-KQ0106)
- Materiale: Schiuma
- Dispositivi compatibili: Dirt Devil SD4000 Canister Vac, Dirt Devil SD40000 Vision Pet Canister Vac, Dirt Devil SD40010 EZ Lite Canister Vac
- Numero di pezzi: 1
- Riutilizzabilità: Washable and reusable (after proper drying)
Garanzia e supporto
Information regarding specific warranty terms for the Royal Dirt Devil Foam Filter #1KQ0106000 is not provided in this document. For warranty details, please refer to the original product packaging or contact Royal/Dirt Devil customer support directly. You may also visit the official Royal or Dirt Devil websito per ulteriore assistenza e informazioni sui prodotti.
For additional support or inquiries, please consult the manufacturer's official website or your product's main user manual.
