ise KNX Remote Access
Specifications:
- Input Voltage: DC 24 V to 30 V SELV
- Power Consumption: 2 W
- Bus Connection Terminal: TP1, S-Mode typical 6 mA
- IP Connection: 10/100 Mbit/s
- Dimensions: 2 module units (DIN rail mounting)
Product Information:
The SMART CONNECT KNX (IP/IP) device is designed for KNX applications. It allows for communication with KNX systems and can be configured using ETS software.
Product Usage Instructions:
Installation and Electrical Connection:
- Mount the device according to DIN EN 60715 standards.
- Connect the external power supply to the connection terminal (3) using a white-yellow connection clamp.
- Connect the KNX bus line to the red-black bus terminal (2).
- Connect the network cable with RJ45 plug to the RJ45 socket (7).
Programming and Setup:
- Remove the cover by pressing the side of the cover (refer to figure 3).
- Ensure the programming LED (4) is lit. Set a physical address for the device.
- Complete the configuration by marking the device with the physical address and loading application software and parameters.
Disposal Information:
Properly dispose of this product following local regulations. Do not discard in regular household waste.
FAQ:
Q: What is the recommended power supply voltage for this device?
A: The recommended input voltage is DC 24 V to 30 V SELV.
Q: How can I configure this device for use with KNX systems?
A: The device can be configured using ETS software. Follow the provided instructions for setting physical addresses and loading parameters.
Documents / Resources
![]() | KNX Remote Access |
References
- ise Individuelle Software und Elektronik GmbHwww.ise.de
- User Manualmanual.tools
Published: August 29, 2024
Updated: August 30, 2024


