Notendahandbók fyrir fjarstýringu fyrir fjöltíðni klónun frá tecmaniaworld

Forritunarhandbók

Mynd 1

Programming of your new remote with an already programmed remote control:

1. Press simultaneously the two top buttons on the new remote. Release the buttons.
2. Press again at the same time on the top two buttons on the new remote. The LED of the new remote control flashes three times. Release the buttons.
3. Press the button you want to use. The LED of the new remote will flash once. Release the button.
4. Place the new remote and the original remote “back to back”
5. Press the button on the old remote, which you want to copy.
6. The LED on the new remote begins to flash rapidly, after a few seconds it will flash 3 times slowly.
7. Slepptu hnappinum á upprunalegu forrituðu fjarstýringunni.
8. Bíddu í nokkrar sekúndur. Nýja fjarstýringin mun blikka einu sinni.
9. Nýja fjarstýringin þín er nú forrituð.

Note: You can program all other buttons on your remote with the same procedure.

Regulation of the transmission power of the new remote:

Note: If after programming the new remote it works only on a very short range (a few centimeters away from the motor or 1-2 m), please try the following instructions.

1. Opnaðu nýju fjarstýringuna alveg.
2. On the board of the new remote there is at the top right corner a small screw. (see Fig 1).
3. Go next to your receiver, turn the screw at small intervals and test the transmitter again.
4. At a certain point, the transmitter should operate normally.

www.tecmaniaworld.com

Skjöl / auðlindir

tecmaniaworld fjöltíðni klónunar fjarstýring [pdfNotendahandbók Fjöltíðni klónunar fjarstýring, klónun fjarstýringar, fjarstýring, stjórnun

Heimildir

• Notendahandbók