IKEA Bedside Table
Yfirview
This manual section covers the listed hardware/parts and provides step-by-step instructions for assembling the cabinet base frame and assembling the cabinet and drawer.
Hardware & Parts Reference
| Vélbúnaður A | 15×9 mm — 12 pcs |
| Vélbúnaður B | 8×30 mm — 12 pcs |
| Vélbúnaður C | M8×40 mm — 4 pcs |
| Vélbúnaður D | M6×50 mm — 4 pcs |
| Vélbúnaður E | — 2 stk |
| Vélbúnaður F | ST5×50 mm — 4 pcs |
| Vélbúnaður G | — 1 stk |
| Hardware H | ST4×35 mm — 4 pcs |
| Hardware I | ST3.5×12 mm — 8 pcs |
| Hardware J | — 1 stk |
| Hardware K | M4×20 mm — 1 pc |
| Hardware L | — 4 stk |
| Hardware M | — 1 stk |
| Hardware N | ST3.5×18 mm — 4 pcs |
| Hardware O | — 12 stk |
Samsetningarleiðbeiningar
- Base & frame assembly: Assemble rails 14 and 15 using bracket K (repeat for two corners).
- Add rail 13 to the assembly of rails 14 and 15; tighten using screw C with wrench L.
- Complete the base frame by adding rail 12 to rails 13, 14, and 15; secure bracket K with screw C and wrench L.
- Attach the assembled base frame to the bottom of the cabinet body (part 2) using screws D.
- Cabinet & drawer assembly: Attach side panels 8 and 9 to base panel 7 using screws A.
- Slide back panel 11 into the grooves of side panels 8 and 9.
- Secure top panel 10 to the side panels 8 and 9 using four screws G.
- Attach drawer handle I to the drawer front using screw J.
- Attach drawer slides (E2) to the sides of the drawer using screws H.
- Insert the completed drawer into the main cabinet unit.
- Assembling rails 14 and 15 using bracket K. The ‘x2’ indicates this is done for two corners. Inset showing the placement of bracket K onto the rail corner.
- Adding rail 13 to the assembly of rails 14 and 15. An 80% completion circle is shown. Inset showing screw C being tightened with wrench L to secure the rail.
- Completing the base frame by adding rail 12 to rails 13, 14, and 15. An 80% completion circle is shown. Inset showing bracket K being secured with screw C and wrench L.
- Attaching the assembled base frame to the bottom of the cabinet body (part 2) using screws D.
- The base frame is shown fully attached to the cabinet body. A 100% completion circle is shown. Inset showing wrench L being used for final tightening of the assembly.
- Úrslitaleikur view of the assembled cabinet. Inset showing hardware M and N being used to attach a component to the drawer front (part 6).
- Side panels 8 and 9 are attached to base panel 7 using screws A. Inset diagrams show screw alignment.
- Drawer slides E2 are attached to the sides of the drawer (8 and 9) using screws H. An inset shows the slide detail.
- The completed drawer is inserted into the main cabinet unit.
Skjöl / auðlindir
 | Náttborð |
Heimildir
- Notendahandbókmanual.tools
Published: July 13, 2026