IB-CRS-007 Running Boards Side Steps
Installation Guide
Rocker Step
PART NO. IB-CRS-007
FITS: 2019-Up Chevy Silverado 1500 Regular Cab
2019-Up GMC Sierra 1500 Regular Cab
2020-Up Chevy Silverado 2500/3500 Regular Cab
2020-Up GMC Sierra 2500/3500 Regular Cab
IB-CRS-007 Running Boards Side Steps
Torque & Tools
| Fastener Size |
Tightening Torque(ft-lbs) | Wrench Required | Allen Wrench Required | ||
| □ 6mm | □ 7-8.5 |  |
□ 10mm |  |
□ 4mm |
| ■ 8mm | ■ 18-20 | ■ 13mm | □ 5mm | ||
| □ 10mm | □ 35-40 | □ 16mm | □ 6mm | ||
| □ 12mm | □ 60-70 | □ 18mm | □ 8mm | ||
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT DEPEND ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID POSSIBLE
INJURY OR DAMAGE TO THE VEHICLE.
Part List
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE DRIVER SIDE INSTALLATION
STEP 1
Start the installation under the Driver/Left side of the vehicle. Remove the plastic plugs along the bottom edge of the body, (Fig 1). Directly above each threaded insert is a top mounting location on the side of the body panel. Hold a Mounting Bracket up in place to help determine the correct mounting holes to use along the body.
NOTE: Thread an 8mm Hex Bolt into the threaded inserts to clear paint as required.
(Fig 1) Driver/Left front mounting location
STEP 2
Select (1) Driver/Left Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Fig 2). Do not fully tighten hardware.
(Fig 2) Attach (1) Driver/Left Mounting Bracket to the front mounting location
STEP 3
Repeat Steps 1 & 2 to attach the remaining (1) Driver/Left Mounting Bracket to the rear mounting location along the body panel, (Fig 3).
(Fig 3) Driver/Left rear mounting location
STEP 4
Select the Driver/left Rocker Step. NOTE: The Driver/left Rocker Step will have a “07-L” on the front. Place the Running Board onto the Mounting Brackets.
IMPORTANT: Do not slide the Running Board front to back or damage to the finish may result. Attach the Running Board to the Mounting Brackets with (4) 8mm Combo Bolts, (Fig 4).
(Fig 4) Attach the Driver/Left Rocker Step to the (2) Mounting Brackets
STEP 5
Level and adjust the Rocker Step and fully tighten all hardware.
STEP 6
Repeat Steps 1—5 to attach the Passenger/Right Rocker Step.
STEP 7
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
Documents / Resources
 |
IRONBISON IB-CRS-007 Running Boards Side Steps [pdf] Installation Guide IB-CRS-007 Running Boards Side Steps, IB-CRS-007, Running Boards Side Steps, Boards Side Steps, Side Steps |