IRC IMMERSIONRC v2 RF Power Meter
Product Information
Specifications
- Product Name: RF Power Meter v2
- Meter Versions: v2
- Display Modes: Meter Display, PowerScope Display, Sniffer Display
- Signal Type: RF
Product Usage Instructions:
Meter Display Mode
In Meter Display Mode, the RF Power Meter v2 shows the current power level of the RF signal being measured.
Setup Menu
Access the Setup Menu to configure settings such as units (dBm or mW) and display brightness.
PowerScope Display Mode
Switch to PowerScope Display Mode to visualize the power spectrum of the RF signal for detailed analysis.
Sniffer Display Mode
The Sniffer Display Mode allows you to detect and analyze RF signals in the vicinity.
Calibration:
Ensure accurate measurements by calibrating the RF Power Meter v2 periodically as per the provided instructions.
Conducted vs. Radiated Power
Understand the difference between conducted and radiated power measurements for proper usage of the meter.
Signal Frequency
Take note of the signal frequency being measured to ensurecompatibility with the RF Power Meter v2.
FAQ:
How Accurate Is the RF Power Meter v2?
The accuracy of the RF Power Meter v2 is not specified in the manual. It is recommended to calibrate the meter regularly for reliable measurements.
What is the Best Way to Measure Signals >1 Watt?
For signals above 1 Watt, it is advisable to use an attenuator to prevent damage to the meter. Consult the manual for guidance on selecting the appropriate attenuator.
How Does Signal Type Affect Measurement?
The RF Power Meter v2 is designed for RF signals. Ensure that the signal type matches the capabilities of the meter for accurate readings.
“`
RF Power Meter v2
Operator’s Manual Rev 1.20 – Sep 2022
ImmersionRC is a member of the Orqa group of companies.
RF Power Meter v2
Introduction
- Meter Versions
- Meter Display Mode
- Setup Menu
- PowerScope Display Mode
- Sniffer Display Mode
- A Word on Calibration
- Think in dBms, not mW!
- Conducted vs. Radiated Power
How Does The Meter Work?
How Accurate Is It?
- Harmonics
- Attenuator Leakage
- Signal Type
- Signal Frequency
Measuring Vtxs >1Watt
- As described in the previous s…
- What you want to buy is an att…
- If a 3dB attenuator is used you…
- Take note that when you make…
- Best way to do that is to use a …
- Now repeat this same measur…
Documents / Resources
 |
IRC IMMERSIONRC v2 RF Power Meter [pdf] Instruction Manual v2 RF Power Meter, v2, RF Power Meter, Power Meter, Meter |
