P2V ULTRA
OBJECT CAMERA
IPEVO P2V ULTRA OBJECT CAMERA
* For a full user manual, FAQ & tech support, visit www.ipevo.com/products/p2v-ultra/support
All trademarks, logos, and brands are the property of their respective owners and are used for identification purposes only.
Get to know your IPEVO P2V ULTRA
Software Download
IPEVO Visualizer Scan, record, and capture images with IPEVO cameras. www.ipevo.com/visualizer
IPEVO CamControl Adjust the camera settings without using the buttons. www.ipevo.com/camcontrol
Caution
Do not use/store the product in the following places:
- Near heat sources
- Sandy or dusty places
- Locations with high humidity
FCC Declaration
Federal Communications Commission (FCC) Statement
This device complies with Pert 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
For product available in the USA/Canada market, only channel 1 一 11 can be operated. Selection of other channels is not possible.
Declaration of the Presence Condition of the Restricted Substances Marking
| USB : CDVU-161P Equipment name Type designation [Type] |
||||||
| Unit | Restricted substances and its chemical symbols | |||||
| Lead (Pb] |
Mercury (Hg] |
Cadmium (Cd) |
Hexavalent chromium (CH) |
Polybrominated biphenyls (PBE3] |
Polybrominated diphenyl ethers (PBDE) |
|
| 0 | 0 | 0 | 0 | 0 | 0 | |
| 0 | 0 | 0 | 0 | 0 | 0 | |
| 0 | 0 | 0 | 0 | 0 | 0 | |
| 0 | 0 | 0 | 0 | 0 | 0 | |
| Note 1 : “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of the restricted substance exceeds the reference percentage value of presence condition. Note 2 : “o” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence. Note 3 : The “-” indicates that the restricted substance corresponds to the exemption. |
||||||
PRODUCT :…………………
IPEVO P2V ULTRA
OBJECT CAMERA
MODEL :……………………
CDVU-16IP…………………
INPUT : 5V⎓0.5A
Operation temperature : 0° C to 40° C
MADE IN THAILAND
Documents / Resources
 |
IPEVO P2V ULTRA Object Camera [pdf] User Guide P2V ULTRA Object Camera, P2V ULTRA, Object Camera, Camera |