instructables MD-R001TN FORM 2 and 3 PRINTER Laser Modeling
APPLYLABWORK PRINTING TIPS
FORM 2 & 3 PRINTER
Laser Modeling – Tan
(MD-R001TN)
Check:
- UV optical pathways are clean
- Vat is free of defect
- Resin is well shakened
Open-Mode (Form2): Printer at idle
- Tap touchscreen “Printer” icon, open “Settings” menu
- Select Open Mode
- Select On
Cartridege (Form2 & 3):
Refill corresponding cartridge e.g.FormLabs Grey version 4 cartridge. Open air vent, turn cartridge upside down, drip dry through air vent for 10 mins to avoid cross contamination, refill, shake well for 2 mins, insert & print (may work up to 2 refills before locked by FL software).
Warning: Cross contamination of resins could cause size inaccuracy or wavy line.
Alternative Solution: North America , Other Regions
PreForm Setting:
Select Printer: Form 2 or Form 3
Material: Grey V4 (FLGPR04)
Suggest Layer Thickness 100~25
Washing:
IPA 95%, maximum for up to 5 minutes, gently shake-off / blow-off excess IPA quickly, set print in a shaded airy place to dry completely before curing.
Extended time in IPA causes deformation.
Dried print might be a little tacky to touch.
Post-curing:
For optimal material performance, the condition of FormCure is 60℃ / 45 mins.
Storage:
- Keep resin away from heat & light.
- NOT accessible to children.
- Filter used resins before storage.
Note: - Keep print environment well ventilated.
- Avoid direct contact to skin or eyes. Rinse cautiously with water / soap and water for several minutes if contact to eyes / skin.
- Wear chemically-resistant gloves like nitrile or neoprene (not latex) when handling.
- DO NOT pour uncured resin down the drain. Abandoned resin can be cured by sunlight before discarding.
WARNING:
Contact with uncured resin may cause eye or skin irritation and allergic reaction.
Design Concept Series
Documents / Resources
![]() |
instructables MD-R001TN FORM 2 and 3 PRINTER Laser Modeling [pdf] Instruction Manual MD-R001TN, FORM 2 and 3 PRINTER Laser Modeling, MD-R001TN FORM 2 and 3 PRINTER Laser Modeling, 3 PRINTER Laser Modeling, Laser Modeling |