
INIM Electronics PREVIDIA-C-COM Previdia Compact Control Panel
Technical specifications
- Power Supply Voltage: 19 / 30 V
- Current Draw: 40 mA
- Operating Temperature: –
- Capacity of SDcard: –
- Imax RS485: 200 mA

Product Usage Instructions
Power Supply and Connection
- The PREVIDIA-C-COM requires a power supply voltage of 19-30 V with a current draw of 40 mA. Ensure proper connection to the RS485 and RS232 ports following the specified pin configurations.
Mounting
- When mounting the PREVIDIA-C-COM, make sure to follow the provided instructions for secure installation. Avoid connecting to 220V or using a battery as indicated in the manual.

Mounting with PREVIDIA-C-DIAL

Wiring the board

Download

Directive 2014/53/EU
- Hereby, INIM Electronics S.r.l. declares that these Previdia control panels are in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. This product may be used in all EU Countries.
Documents for the users
- Declarations of Performance, Declarations of Conformity and Certificates concerning to INIM Electronics S.r.l. products may be downloaded free of charge from the web address www.inim.it, getting access to Extended Access and then selecting “Certifications” or requested to the e-mail address info@inim.it or requested by ordinary mail to the address shown in this manual.
- Manuals may be downloaded free of charge from the web address www.inim.it, getting access to Extended Access and then selecting “Manuals”
WEEE
- Informative notice regarding the disposal of electrical and electronic equipment (applicable in countries with differentiated waste collection systems)
- The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed of correctly at the end of its working life and should never be disposed of together with general household waste. The user, therefore, must take the equipment that has reached the end of its working life to the appropriate civic amenities site designated to the differentiated collection of electrical and electronic waste. As an alternative to the autonomous-management of electrical and electronic waste, you can hand over the equipment you wish to dispose of to a dealer when purchasing new equipment of the same type. You are also entitled to convey for disposal small electronic-waste products with dimensions of less than 25cm to the premises of electronic retail outlets with sales areas of at least 400m2, free of charge and without any obligation to buy.
- Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment and its environmentally compatible disposal helps to avoid possible negative effects on the environment and on health and favours the reuse and/or recycling of the materials it is made of.
Copyright
- The information contained in this document is the sole property of INIM Electronics s.r.l. No part may be copied without written authorization from INIM Electronics s.r.l. All rights reserved.
Compliance and Certifications
- The product complies with standards including EN 54-2, EN 54-4, EN 54-21, and EN 12094-1. For detailed compliance information, refer to the Declarations of Performance and Conformity available for download on the manufacturer’s website or by contacting them directly.
Inim Electronics S.r.l.
Centobuchi, via Dei Lavoratori 10
63076 Monteprandone (AP) Italy
Tel. +39 0735 705007
Fax +39 0735 70491
info@inim.it _ www.inim.it
FAQs
What is the primary power supply voltage for the PREVIDIA C COM?
The primary power supply voltage required is between 19 to 30 V.
Can I connect the device to a 220V power source?
No, the device should not be connected to a 220V power source as indicated in the manual.
Is a battery required for operation?
No, the device does not require a battery for operation.
Documents / Resources
![]() | PREVIDIA-C-COM Previdia Compact Control Panel |
References
- Inim Electronicswww.inim.it
- User Manualmanual.tools
Published: October 29, 2025

