Foam Fork Foamcore Fork
Instructions

Introduction

Thank you for choosing Impact.
Impact’s FOAM-FORK attaches to any foamcore board a 3/8-inch thick or larger.
Its ideal for employing foamcore as a bounce board or flag in the studio or on location. This photo and video accessory features a knuried baby pin for secure and nonslip attachment. And for easy positioning, its compatible with grip accessories with a 5/8-inch receiver like a grip head or super clamp.

Precautions .

• Please read and follow these instructions, and keep this manual ina safe place.
• The tines are sharp. Handle the unit with care.
• Keep this product away from children.
• Allimages are for lustrative purposes only.

Specifications

Setup

Attaching a Foamcore Board
Foamcore boards that are a minimum of 3/8-inch thick are recommended.
Center the tines and press them into the foam core.
Mounting the Foam Fork

1. Attach a grip head to the C-stand’s baby pin, and place a sandbag over the C-stand’s big leg to prevent tipping.
2. Slide a grip arm through the grip head.Make sure to use the correct orientation: position the grip head end of the grip-arm to the right when the grip head’s large locking knob faces you.
3. Insert the FOAM-FORK’s baby pin into the grip arm’s 5/8-inch hole. Adjust the foamcore to the desired position, and tighten the locking knob clockwise unil secure.

Note: Make sure the C-stand’s big le s in line with the grip arm.

One-Year Limited Warranty

This Impact product s warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. The warranty provider’s responsibliy with respect to this limited warranty shall be limited solely to repair or replacement, atthe provider’ discretion, of any product thatfals during normal use of this product in its intended manner and inits intended environment. Inoperabilty of the product or partls) shall be determined by the warranty provider.Ifthe product has been discontinued, the warranty provider reserves the right to replace it with a model of equivalent quality and function.
This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse, improper installation or maintenance.
EXCEPT AS PROVIDED HEREIN, THE WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
This warranty provides you with specific legal rights, and you may also have additional rights that vary from state to state To obtain warranty coverage, contact the Impact Customer Service Department to obtain a return merchandise authorization (“RMA”) number, and return the defective product to Impactalong with the RMAnumber and proof of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.
For more information or to amange service, visit www.impactstudiolighting.com or call Customer Service at 212-594-2353, Product warranty provided by the Gradus Group.

www.gradusgroup.com
Impactis a registered trademark of the Gradus Group. IMPACT*
© 2024 Gradus Group LLC.
Al Rights Reserved. 

Documents / Resources

impact KCP-610 Foam Fork Foamcore Fork [pdf] Instructions KCP-610 Foam Fork Foamcore Fork, KCP-610, Foam Fork Foamcore Fork, Fork Foamcore Fork, Foamcore Fork

References

• User Manual