ILLUXTRON HV-FD Downlights
SYMBOL EXPLANATION
Protection class I: the fi tting has an earthing connection. The earth wire (yellow/green) has to be connected to the clip marked with .
Protection class II: the fi tting is double insulated and must not be connected to an Earth.
Protection class III: the fitting is only suitable for very low voltage supply.
This fitting should only be installed indoors
Only when the product is installed in a closed ceiling may it be exposed to water splashes, and only on its front side. (IP20/IP44: Strada 75 and Fido 98. IP20/IP65: Linea 75/120, Fabio 75 and Fluxe 75.)
The lighting fitting – as well as all other products from the collection – is designed, produced and tested in accordance with the strictest European safety standards (EN 60.598).
Disposal of your old product: Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. Please inform yourself about the local separate collection system for electrical and electronic products.
The fitting is suitable for fi xing to normal fl ammable surfaces. Recessed luminaires can under no circumstances be covered with insulation material or other similar materials.
SAFETY INSTRUCTIONS
If in doubt, consult a qualified electrician or contact your retail outlet. Ensure that you always install the fi tting to the relevant regulations.
ENERGY CLASS
These products contains a light source of energy effi ciency class:
G (2200-3000K) / F (2700K/3000K) / G (4000K)
Models
- Fluxe 75
- Fluxe 90
- Linea 75
- Linea 120
- Strada 75
- Strada 90
- Fido 98
- Fido 108
- Fabio 75
= Available colors | Also available with (WS) wire springs.
DIMMER COMPATIBILITY
Please check our website/catalogue/datasheets for the latest HV dimmer recommendation list and more information.
DIMENSIONS
- 75 HV-FD (IP20/IP44 + IP20/IP65)
- Hole size / Springs
CS (concrete) springs
WS (wire) springs
- 90 HV-FD (IP20)
- Hole size / Springs
CS (concrete) springs
WS (wire) springs
Double terminals for looping
- 120 HV-FD (IP20/IP65)
- Hole size / Springs
GS (gyproc) springs
WS (wire) springs
120-165 mm: For plasterboard ceilings or similar harder materials
120-145 mm: For soft ceiling tiles. We recommend using a wooden plate or a ceiling ring on the reverse side of the tile - Fido 98 (IP20/IP44)
- Hole size / Springs
CS (concrete) and WS (wire) springs
- Fido 108 (IP20)
- Hole size / Springs
Customer Support
Mercuriusweg 19 4382 NC Vlissingen The Netherlands
info@illuxtron.com
+31 (0)85 773 63 60
www.illuxtron.com
Documents / Resources
 |
ILLUXTRON HV-FD Downlights [pdf] Instruction Manual HV-FD, HV-FD Downlights, Downlights |
