igloo EK2 Keypad 2 Installation Guide

igloo EK2 Keypad 2

What’s Included

• A: Keypad
• B: Mounting Plate
• C: Mounting Screws
• D: Anchor Bolt
• E: Torx (T10) Screwdriver
• F: Battery Cover

Installation Steps

Mounting with Screws
Find a place to install your Keypad. Installing it closer to your locks and entryway will enable easier operation.

What You Need

• Step 1: Separate the Mounting Plate
  Separate the mounting plate (B) from the keypad (A) by loosening the screw from below. Use the supplied Torx (T10) Screwdriver (E).
• Step 2: Select Install Location
  The Keypad 2 should be installed 86cm – 120cm (34 – 48 in) above the ground to ensure ADA compliance. Ensure that the keypad is not more than 5m away from the linked lock to ensure strong connectivity.
• Step 3: Mark Mounting Holes
  Mark out two holes for securing the mounting plate (B). Use the mounting plate or Drill Sheet as a reference for marking the holes. The distance between the holes should be 80 mm / 3.15 in.
  
• STEP 4
  IMPORTANT To ensure secure installation, use the recommended pilot hole and anchor bolt guidelines below. Mounting Pilot Hole Anchor Surface Diameter Bolt? Wood 2 mm / 5/64″ X Sheetmetal 2 mm / 5/64* X Brick 6 mm / 15/64″ D Concrete 6 mm / 15/64″ Masonry 6 mm/15/64″ D Drywall 6 mm/15/64″ *The pilot holes should be drilled to a depth of 50mm / 2″
• Step 5: Insert Anchors if Required
  Insert anchor bolts if required. Secure the mounting bracket (B) by tightening the mounting screws (C).
• Step 6:Secure Mounting Bracket.
• Step 7: Insert Batteries
  
  • Carefully remove the battery cover (F) by loosening the two screws with the Torx (T10) screwdriver (E).
  • Carefully replace the battery cover (F) by tightening the two battery screws with the Torx (T10) Screwdriver.
  • Place the Keypad (A) onto the mounting plate (B) as shown. Secure it with the Torx (T10) screwdriver (E) from below.
• Step 8: Assemble the Keypad

That’s It!
You have now installed your Keypad 2 device. Please download the igloo works app to proceed with pairing.

Features

• Control any igloo Lock
  Harness the power of no-tour PIN Codes & NFC credentials on multiple igloo locking devices.
• Designed for Durability
  With an IK-09 Impact & IP66 Protection, the Keypad 2 is designed for heavy use.
• Works for Everyone
  Whether using PIN codes or key fobs, Keypad 2 eliminates reliance on mobile devices.
• Volume Control
  Adjust the volume according to your preference. Select from levels 0 (mute) to 5 (loudest).
• Easy Installation
  A zero-wiring setup means your Keypad can be online within minutes. Can be mounted on a variety of surfaces with anchors and fasteners for wood, brick, drywall, concrete and masonry.
• Flexible NFC Credential Suite
  Create duration, permanent or scheduled NFC access on physical fobs or mobile devices.
• Physical Keypad
  Accessible, tactile buttons built for zero-error input.
• Low Battery Alert
  Intuitive audio and visual alerts will prompt you to change the batteries when it runs low.
• Security Lockout
  Keypad is disabled after several incorrect access attempts to ensure your property is always secure.

Audio and LED Indicators