IFIXIT 300x Front Casing Replacement Owner’s Manual

IFIXIT 300x Front Casing Replacement

IFIXIT 300x Front Casing Replacement

INTRODUCTION

Steps for replacing the outer casing of a Sony PSP-3000.

Symbol TOOLS:
Phillips #00 Screwdriver (1) Spudger (1)

Symbol PARTS:
Sony PSP 3000 Front Case (1)

Step 1 — Battery

  • Place the PSP face down and locate the battery cover on the left side of the device.
  • Lift and remove the battery cover to reveal the battery.
  • Remove the battery
    Battery

Step 2 — Front Casing

  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
    Front Casing

Step 3 

  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.
    • Two are located behind the battery’s warranty sticker.
    • Two are located on the right side of the PSP
      Front Casing

Step 4 

  • Next, unscrew the two screws located at the top of the PSP.
    Front Casing

Step 5 

  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).
    Front Casing

Step 6 

  • Slide the spudger in between the outer casing of the PSP, beginning at the “R” shoulder button, and gently pry off the casing.
  • Remove the front casing completely
    Front Casing

To reassemble your device, follow these instructions in reverse order.

Logo

Documents / Resources

PDF thumbnail300x Front Casing Replacement
Owner's Manual · 300x Front Casing Replacement, 300x, Front Casing Replacement, Casing Replacement, Replacement

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.