iEBELONG ED154 Wireless Self-Powered Door and window Sensor Instructions
iEBELONG ED154 Wireless Self-Powered Door and window Sensor

Product Description

This kinetic door contact could be paired with SY8989NEW controller and installed on the door or window to turn on /off the light once open or close it.
Product Description

Product Parameters

Power Supply: Self-powered(No battery)
Working Frequency: 433MHz
Working Temperature: -20°C~+55°C
Control Distance: 80m (outdoor) 30m (indoor)
Life time: >100,000 times
Dimension: 109*27*17 mm

Installation

  1. Remove the double-sided tap on the back
    Installation
  2. Fix the door contact on selected door.
    Do not attach to metal security doors as this may affect signal transmission.
    Installation`

Paring with controller

  1. Press pairing button on receiver for around 3 seconds until the indicator light blinks slowly
    Paring with controller
  2. Open/close the door quickly. Pairing will be successful if the indicator light stops blinking
    Paring with controller

Documents / Resources

iEBELONG ED154 Wireless Self-Powered Door and window Sensor [pdf] Instructions
ED154, Wireless Self-Powered Door and window Sensor, ED154 Wireless Self-Powered Door and window Sensor

References

Leave a comment

Your email address will not be published. Required fields are marked *