idaTaLINK FO2BC-SR-DS Maestro SR Radio Replacement Interface
WIRING DIAGRAM
RETAINS STEERING WHEEL CONTROLS, FACTORY AMPLIFIER AND MORE!
INSTALLATION INSTRUCTIONS
STEP 1
Remove the factory radio
If using head unit adapter (sold separately), connect SRFO2 harness to adapter and skip to step 2.
• Unbox the aftermarket radio and locate its main harness.
• Cut and remove the black 20 pin connector from the SRFO2 T-harness and connect the wires, shown in the wiring diagram, from aftermarket radio main harness to the SRFO2 T-harness and match the wire functions.
Note: Purple/white is a low current positive output used to trigger the radio only. Do NOT connect to anything other than the radio’s reverse input. Refer to radio wire chart for radio’s reverse light wire color.
If no camera is installed/desired, do not connect the radio’s reverse wire. If installing an aftermarket camera, do NOT connect power for the camera to the Maestro’s purple/ white wire or module damage will occur.
STEP 2
• Plug the harnesses into the aftermarket radio.
• Connect backup cam to radio (if equipped).
• Plug the Data cable to the iDatalink port of the aftermarket radio.
Note: On Pioneer radio, ensure that there is nothing plugged into the W/R port.
STEP 3
Without AMP:
• Ensure that the SR-FO2 4-pin white plugs are connected. With AMP:
• Unlug the SR-FO2 4-pin white connectors.
• Connect the SR-FO2 4-pin white to 4-pin white connector with RCAs.
• Connect the RCAs to the radio outputs: white/left front, gray/right front.
STEP 4
(If present)
• Connect the black 2-pin connector to the SR-FO2 backup camera adapter.
• Connect the SR-FO2 12-pin adapter to the vehicle screen harness.
STEP 5
• Connect the factory radio harness to the SR-FO2 T-harness.
STEP 6
• Connect the SR-FO2 harness to the Maestro SR module.
• Connect the Data cable.
Test your installation.
WIRING DIAGRAM 1
ADDITIONAL INFORMATION AND ACCESSORIES
HEAD UNIT ADAPTER:
ACC-HU-PIO1, SON1, KEN1, KEN2, ALP1
Installation, product information, vehicle specifc videos. VIDEO HELP
Last fash information, steering control confguration, vehicle information. VERIFY FLASH
Software to program module. WEBLINK
MAESTRO SR RESET PROCEDURE:
Turn the key to the OFF position, then disconnect all connectors from the module.
Press and hold the module’s programming button and connect all the connectors back to the module. Wait, the module’s LED will fash RED rapidly (this may take up to 10 seconds).
Release the programming button. Wait, the LED will turn solid GREEN for 2 seconds to show the reset was successful.
TECHNICAL ASSISTANCE
Phone: 1-866-427-2999
Email: maestro.support@idatalink.com
IMPORTANT: To ensure proper operation, the aftermarket radio needs to have the latest firmware from the manufacturer. Please visit the radio manufacturer’s website and look for any updates pertaining to your radio.
Documents / Resources
 |
idaTaLINK FO2BC-SR-DS Maestro SR Radio Replacement Interface [pdf] Installation Guide HRN-SR-FO2, SFO2, FO2BC-SR-DS, FO2BC-SR-DS Maestro SR Radio Replacement Interface, FO2BC-SR-DS, Maestro SR Radio Replacement Interface, Radio Replacement Interface, Replacement Interface, Interface |
