iCSeecam EseeCloud Camera App Instruction Manual

Pre use settings

1. For products with batteries, please turn the power switch to “ON” mode, For products without batteries, please connect the camera to the power adapter provided with the product, or connect the camera to a power source.
2. Please place the wifi camera with in 2 meters of the router when connecting to the Internet.
3. Connecting the phone to the WiFi and make sure know the exact WiFi password.

Add device

1. .WIFI Camera:
   Step 1:Please connect the device to the power supply to ensure that the device is powered on normally;
   Step 2: Log in to the “Esee cloud” APP, turn on the Bluetooth function of the mobile phone, and click the “+” add button on the interface to enter the automatic search device interface:
   Step 3: Select the device you need to add, click the “Add” button on the right, and follow the interface guidance to add the device:
   Note: If you do not find the device you want to add after waiting 10son the Bluetooth search interface, please click “Scan to add” below to scan the QR code on the device body to add the device.
   
2. 4G Camera:
   Step 1: Please connect the device to the power supply to ensure that the device is powered on normally;
   Step 2: On the automatic search interface, click ‘Scan to add” to enter the scan code interface;
   Step 3: Scan the QR code on the device body, and add the device according to the interface guidance.
   Note: The 4G camera can only connect after inserting a SIM card. Please insert a data-enabled SIM card first, then turn on the camera or connect it to a power source to complete the connection.
   

Note:

1. If you cannot find the QR code on the device body, please choose other adding methods according to the device type:
   1. Insert the SIM card or connect the network cable to use the device, please click “Manual Add’, enter the device ID to add the device;
   2. For the device used to connect to the router WiFi. please click” Camera scan code to add” or “Camera hots pot add” to add the device according to the interface guidance;
2. If the location where you install the camera cannot be connected to the Internet, please click the “WiFi Connection” button in the upper right corner of the WiFi selection interface, and switch to “Direct Connection” in the pop-up window.

Information for users

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and may radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and back on, the user is encouraged to attempt to correct the interference by one or more of the following measures.

• Reorienting or repositioning the receiving antenna.
• Increasing the distance between the equipment and the receiver.
• Connecting the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance may cause the user to lose operation. or modifications not expressly approved by the manufacturer responsible for compliance could cause the user to lose the right to operate the equipment.