Home » Hypertherm » Hypertherm HPR400XD HyPerformance Plasma System Instructions 
Hypertherm HPR400XD HyPerformance Plasma
HPR400XD and HPR800XD* CE models
| Requirement Idle With load |
| The following values were measured at the rated duty cycle for the system at the highest output power: |
| Output current |
– |
401.63 A |
| Output voltage |
– |
201.68 V |
| Output active power |
– |
80.93 kW |
| The following values were measured at idle state** and at the rated duty cycle for the system at the highest output power: |
| Root mean square (RMS) supply voltage |
401.28 V |
397.28 V |
| Supply active power |
42.16 W |
88.11 kW |
| Total harmonic distortion of the supply voltage (UTHD) |
1.15% |
4.37% |
| The following value was measured at idle state**: |
| Idle state power consumption by the power source |
42.16 W |
– |
| The following value was calculated at the rated duty cycle for the system at the highest output power: |
| Efficiency |
– |
91.85% |
- For HPR800XD cutting systems, the values in the table are for each plasma power supply.
- External devices were disconnected during idle measurement.
A jumper was installed on pins 1 and 3 of TB2 to enable the power supply to remain powered in idle state.
Critical raw materials
| Critical raw material |
Components that contain more than 1 gram |
| Borate |
All printed circuit boards, torch, torch mounting sleeve |
| Magnesium |
Heatsinks |
| Natural graphite |
Pump motor, resistors |
| Phosphorus |
Sheet metal panels |
| Rare earth elements (heavy and light) |
Torch breakaway, pump motor |
| Silicon metal |
Heatsinks, transformers, inductors, IGBT modules |
| Tantalum |
Capacitors |
| Tungsten |
Power resistors, 800 A process electrodes |
ABOUT COMPANY
- HPR400XD, HPR800XD, and Hypertherm are trademarks of Hypertherm, Inc. and may be registered in the
- United States and/or other countries. All other trademarks are the property of their respective holders.
- Environmental stewardship is one of Hypertherm’s core values. www.hypertherm.com/environment 100% Associate-owned
- © 2020 – 2022 Hypertherm, Inc.
Documents / Resources
References
