HDTV CABLE for
Neo Geo AES®
Neo Geo CD™
Quick Start Guide
Setting Up Your HDTV Cable
- Connect the HDTV Cable to the HD port on your HDTV.
- Plug the other end into the A/V OUT on your console.
- Attach the included Micro cable to the HDTV Cable’s Micro port. Attach the other end to a 5V 1A USB power source (not included) to provide external power.
- BEFORE powering on your console, make sure your aspect is configured on your HDTV cable. Moving the switch to the LEFT position indicates a 4:3 ratio. Moving the switch to the RIGHT position indicates a 16:9 ratio.
- Power on your console, and you’re all set!
For troubleshooting, contact us at Support@Hyperkin.com.
Cable Status Guide
The colored LED INDICATOR LIGHTS on your cable tells you your cable’s status. The BLUE light indicates that the cable is transmitting a signal. The RED light indicates the cable is powered ON.
Both Blue and Red Light On = Cable is working
Red Light Only = Sleep Mode
If your cable has no signal for 10 minutes, it will switch to Sleep Mode.
Note: If your cable is not functioning correctly, an additional power source might be required. Connect the included Micro cable into the Micro port on the HD Cable and the other end into a 5V 1A USB power source. The power source is not included.
Please visit www.Hyperkin.com/warranty to register your official Hyperkin product.
Statement of Compliance with EU Directive
Hyperkin Inc., located at 1939 West Mission Blvd, Pomona, CA 91766, declares under our sole
the responsibility that the product, HDTV Cable for Neo Geo AES® / Neo Geo CD™, is in compliance with
the essential requirements and other relevant provisions of Low Voltage Directive (LVD) 2014/35/EU,
EMC Directive 2014/30/EU, and RoHS Directive 2011/65/EU and carries the CE marking.
The full Declaration of Conformity can be requested by emailing:
Email: compliance@hyperkin.com
Company Name: Hyperkin Inc.
Address: 1939 West Mission Blvd, Pomona, CA 91766
© 2020 Hyperkin Inc. Hyperkin® is a registered trademark of Hyperkin Inc. Neo Geo® is a registered trademark of SNK Corporation. Neo-Geo CD™ is a trademark of SNK Corporation of America. Neo Geo Advanced Entertainment System® is a registered trademark of SNK Playmore Corporation. This product is not designed, manufactured, sponsored, endorsed, or licensed by SNK Corporation of America nor SNK Playmore Corporation in the United States and/or other countries. All rights reserved. Made in China.
Documents / Resources
 | HDTV Cable |
References
- User Manualmanual.tools
mi CABLE HDTV para snes emite un ruido molesto
Why is my Hyperkin HDTV cable for SNES making an annoying noise?
The annoying noise or audio interference you are experiencing is often caused by insufficient power being supplied to the cable. To resolve this, please follow these steps:
If the noise persists after providing external power, you can contact Hyperkin support directly at Support@Hyperkin.com.
Read the full Q&A page