i2 Cordless Robot Pool Cleaner
User Guide

Assemble accessories

1) Install the brush.
2) Tie the floating handle.
Charge before use

1. Please charge the robot before its first use. Use original charger only.
2. Make sure the robot is powered off when it is charging.
3. Red light indicates the robot is charging, green light indicates it is fully charged.
4. Robot can take up to 5-6 hours to charge.

Put into pool1) Power it “ON” before putting it into the pool (within 20 seconds).
2) Put it into the pool with the wheels towards the pool.

Lift out of pool

1. When the robot finishes working, it automatically parks at the side of the pool where it can be easily lifted out the pool using the floating handle.

Clean and install

1. Clean the robot and filter tray with water.
2. Reassemble the filter tray, top cover and chassis.

Charge after use

1. Please charge after use and keep the charger and charging port dry.
2. Make sure the robot is powered off when it is charging.
3. Red light indicates it is charging, green light indicates it is fully charged.

Please ensure the charging intervals do not exceed 6 months.
Make sure charging port is completely dry before charging.

Documents / Resources

Hyclor i2 Cordless Robot Pool Cleaner [pdf] User Guide i2 Cordless Robot Pool Cleaner, i2, Cordless Robot Pool Cleaner, Robot Pool Cleaner, Pool Cleaner, Cleaner

References

• User Manual