User Manual Q&AAnswer
Jun 13, 2025 - 03:51 AM
**Installation Steps:**
1. Ensure the machine is powered off and all cables are unplugged.
2. Wait for the machine to cool off if it just finished printing.
3. Detach the Filament Holder, X-Axis (with 3D Printing Module attached), and Controller.
4. Remove the previous Z-Axis and attach the Z-Axis Extension Module.
5. Attach the Filament Holder onto the Z-Axis, then attach the X-Axis and Controller to the Z-Axis.
6. Reconnect all cables that were unplugged in Step 1.
**Configuration Steps in Snapmaker Luban:**
1. Update firmware to version 2.11 and install Snapmaker Luban.
2. Connect your PC to the machine using the provided USB cable and power on the machine.
3. Launch Snapmaker Luban and navigate to Workspace in the left sidebar.
4. Click on Connection, refresh serial ports list, select the serial port of your machine, and click Connect.
5. Choose Custom and the connected toolhead when prompted.
6. Navigate to Machine Settings under Settings, enter values 125, 125, 221 under X, Y, and Z.
7. Under Z axis Extension Module, select On from the drop-down menu and click Save Changes.
8. Use the touchscreen controls to home the axes and level the Heated Bed as per the Quick Start Guide.
**Additional Note:**
If using the 3D Printing Module, verify the configuration by checking Settings>About>Build Volume on the Touchscreen.
For more detailed instructions and safety precautions, refer to the official Snapmaker Original Z-Axis Extension Module Installation Guide.
Add New Comment