S3 Round Tag Locator Device
Product Information
Specifications:
- Compliance: Part 15 of FCC Rules
- Radiation Exposure Limits: FCC approved for uncontrolled
environment - Minimum Distance: 0cm between radiator and body
Product Usage Instructions
Safety Precautions:
It is important to follow these safety precautions while using
the product:
- Do not make any changes or modifications to the device that are
not explicitly approved by the manufacturer. - Ensure the device does not cause harmful interference and can
accept any interference received. - Install and operate the equipment with a minimum distance of
0cm between the radiator and your body to comply with FCC radiation
exposure limits.
Installation:
Follow these steps for proper installation of the device:
- Place the device on a stable surface.
- Connect the necessary cables and power source according to the
manual. - Ensure there is no obstruction around the device to allow for
proper ventilation.
Operation:
Here are guidelines for operating the device:
- Turn on the device using the power button.
- Follow the on-screen instructions or refer to the user manual
for specific operations. - Monitor the device for any unusual behavior or signals of
interference.
FAQ (Frequently Asked Questions)
Q: Can I modify the device for better performance?
A: No, any changes or modifications not approved by the
manufacturer may void your warranty and authority to operate the
equipment.
Q: What should I do if I experience interference while using
the device?
A: Ensure that the device is operating within the specified
guidelines. If interference persists, contact customer support for
assistance.
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Documents / Resources
 |
Huthur S3 Round Tag Locator Device [pdf] User Guide 2BRTK-GLEX01UPLOC1S, 2BRTKGLEX01UPLOC1S, glex01uploc1s, S3 Round Tag Locator Device, S3, Round Tag Locator Device, Tag Locator Device, Locator Device, Device |