QUTIE Portable Label Printer
User Manual
Product Introduction
Appearance and Components
Packing List
LED Indicator Status
Button Operation
- Hold down the power button for a few seconds: Turn on/off the printer
- Press the power button: Position and calibrate the location of thermal label paper and heating line.
Paper Loading
Place your hands on both sides of the side cover, push upward per the direction shown in the figure to open it.
Load the paper as shown in the figure and make sure the print side faces up.
Close the side cover and pull some extra paper.
App Download
Scan the QR code to download App.
https://hereprint.hprt.com/app/hereprint
Connection and Printing
- Turn on the Bluetooth on the phone, open the App,click “Connect printer”,and”Connect”with“Qutie-XXXX”.
- Click “Scan”, and scan the QR code on the paper roll to get more details about the paper.
- Edit the label as needed, and then click “Print”.
Note: App operation shall be subject to the latest version.
Battery Charging
When the battery power is low, the red LED indicator will flash slowly.
Please charge it by the USB cable in time. If you continue printing, it may power off automatically.
Note: The printer can be charged via computer USB port or AC adapter. Please note that the AC adapter is not supplied.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Manufacturer: Xiamen Hanin Co., Ltd.
Address: No.96, Rongyuan Road, Tong’an District, Xiamen, China 361100
E-mail: support@hprt.com
Web: www.hprt.com
Documents / Resources
 |
HPRT QUTIE Portable Label Printer [pdf] User Manual 2AUTE-QUTIE, 2AUTEQUTIE, QUTIE Portable Label Printer, QUTIE, Portable Label Printer, Label Printer, Printer |