HOVERAir MiCo Smart Mini Controller User Guide

HOVERAir MiCo Smart Mini Controller

OVERVIEW

1. Upper Cover
2. Lower Cover
3. 5-Way Button
4. Up Button
5. Down Button
6. Left 2-Way Slide Button
7. Right 2-Way Slide Button
8. Function Button
9. Status Indicator
10. Function Indicator
11. Microphone
12. Speaker
13. USB-C Charging Port

Charge

• Breathing red, yellow, or green : Charging while powered off Solid green: Fully charged
• Fast flashing red: Charging error. Please unplug the charging cable andreconnect it.

Power On/Off

• M iCo powers off automatically after inactivity.
• Open and close the cover, or press any button except the five-way button, to power it on again.

Connection

First-Time Connection

Automatically reconnects after power-on once initially connected.

Disconnect Bluetooth and attempt reconnection.

Controls

Flight Control I Follow Mode
Users cannot enter smart modes such as Zoom Out and Follow using the remote controller; they can only fine-tune the aircraft’s trajectory via the remote controller after takeoff

Flight Control I Manual Mode

Handheld Control

LED Indicators

• Off: Powered off
• Breathing blue: Connecting to the camera
• Flashing blue: Ready to pair
• Solid green: Connected. high battery level
• Solid yellow: Connected, medium battery level
• Solid red: Connected, low battery level
• Breathing red, yellow, or green: Charging while powered off
• Solid green: Fully charged while powered off
• Fast flashing red: Alert, such as very low battery, abnormal temperature, or  charging error
• Alternating red and blue: Updating or uploading logs

Important Notes

• When MiCo loses connection with the camera, it will vibrate and  prompt: “Attempting to reconnect.”
• During an update, please make sure MiCo has sufficient battery and follow the instructions in the App.

Specification

• Model: ZZ-H-2-003
• Dimensions: 54 × 42 × 16.9 mm
• Operating Temperature: -5°C to 40°C
• Battery Capacity: 193 mAh
• Nominal Voltage: 3.7 V
• Charging Limit Voltage: 4.2 V
• Rated Energy: 0.72 Wh
• Charging Method: USB-C
• Battery Life: Up to 5 hours
• Operating Frequency: 2400-2483.5MHz
• BLE: 2402-2480MHz; IC/SRRC/CE/MIC <10dBm EIRP
• Firmware Version: V1.0.0
• Hardware Version: RC420_MB_V11
• IC: 21647-ZZH2003
• CMIIT ID: 26Z44H33R420
• CAN ICES-3(B)/NMB-3(B)

FCC STATEMENT

ISED warning
This device complies with ISED licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesiredoperation of the device.

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement, The device can be used in portable exposure condition without restriction.

MORE INFO

Specifications may vary depending on local laws and regulations. Please refer to your local policies and the actual operating
Shenzhen Zero Zero Infinity Technology Co., Ltd. All rights reserved.environment.

• PA4AH050 V202609

Scan this QR code to view multilingual instructions.