HOVER-1 S-200 Hoverboard User Guide

HOVER-1 S-200 Hoverboard

FEATURES

• Strobe Mode
• Wireless
• Turn Signals

PARTS LIST

• Safety Light
• Remote Control
• Bike Mount
• Helmet Mount
• Handlebar Mount
• USB Charging Cable

REMOTE FUNCTIONS

* Please note, there is an acceleration sensor built into the safety light. Both acceleration and deceleration will activate the light.

CHARGING INSTRUCTIONS

• Turn the S˛200 o˜. Open the charging port and insert the included micro USB cable, Connect the standard USB cable to a USB port
• While charging, a red indicator light will appear. A full charge takes about 2 hours
• When the battery is fully charged, the indicator light will turn green.

MOUNT LIGHT TO HELMET

• Attach one side of the provided double-sided adhesive to the mount
• Place the mount on the rear of your helmet and press °irmly
• Slide the safety light into the mount

MOUNT REMOTE TO HANDLEBAR

• Wrap the mount around your handlebar and tighten it until it’s secure
• Place your remote into the mount

MOUNT LIGHT TO BIKE

• Place the mount around a bar on your bike frame
• Use the provided screw and nut to tighten the mount until it is secure
• Slide the safety light into place

BATTERY CHANGE

• Remove the remote from the rubber mount.
• Locate the battery cover on the back of the remote and use a coin to twist it clockwise to the “OPEN” position.
• Remove the cover and replace the battery.
• Replace the cover and use a coin to twist it counter-clock-wise to close it.