HOTT CD903TF CD Player User Manual

CD Player User Manual
Model: CD903TF

HOTT CD903TF CD Player

Dear user:
Thank you for choosing a portable CD player from HOTT. We wish you a happy experience, please read this manual carefully before use and keep this manual in a safe place for your use.

Accessories

HOTT CD903TF CD Player - Accessories

Start-up Steps

HOTT CD903TF CD Player Start-up Steps

Key Function Description

HOTT CD903TF CD Player - Key Function

POWER : Turn on / Turn off
Long press 3s to start and play. Under backlight starting state, long press 3s above to shut down.
PAUSE 2 : Play/Pause
Short-press to pause/play when playing.
ROCKVILLE 15 Active DJ - icon : Prev song/Fast Rewind
Short-press for once to replay the song when playing, short-press for twice to skip to the previous
track, long-press to fast backward
SKIP : Next song/Fast forward
In the playing state, press short to play the next song, and press long to fast forward
EQ Sound mode: EQ Sound mode /MP3 disk tracklist selecting play
Short-press sequence(BBS)→(POP)→(JAZZ)→(ROCK)→(CLASSIC)→(Back to the original state).
In the playing state, double-clickEQ Sound mode, skip to the DIR track area, and select play. CD has no track function. Double-clickingEQ Sound mode has no effect.
bluetooth device : Play mode
In the playing state, short press to skip to: Single cycle play; ALL: All songs are played in a loop; DIR Select to play in the track area; INTRO: INTROSCAN; SHUF: Play in any order, and unplay the mode.(Note: MP3 disc has full play mode. Except for “select play” in the DIR track area, the CD has all other play modes.)

Bluetooth Function

HOTT CD903TF CD Player - Bluetooth Function

In the playing state, long pressbluetooth device to open the Bluetooth device. The Bluetoothicon flashes to enter the pairing mode. It will automatically connect to an open Bluetooth headset or Bluetooth speaker nearby in the 50s. Long press again to switch to reconnect or disconnect Bluetooth transmit function, The paired device can be reconnected automatically after starting up.

FM Function

HOTT CD903TF CD Player - FM Function

In the playing state, long pressEQ Sound mode the key to enter FM transmission state. Short press ROCKVILLE 15 Active DJ - iconorSKIP adjust the frequency band (frequency band range: 87.5HZ-108.0Hz). Long-press ROCKVILLE 15 Active DJ - iconorSKIP adjust the previous song or next song. Short press the PAUSE 2key to pause/play the song. Then, long press EQ Sound modeto normally exit the FM transmission state and return to the song playing
interface.
Note: When the CD player is in FM transmitting state, use the equipment with FM receiving function and adjust to the same frequency band as the CD player to normally listen to songs. Bluetooth and FM can only be operated in a single, and can not run at the same time.

Back Function Introduction

HOTT CD903TF CD Player - Back Function

  1. HOLD( ON / OFF): Lock/unlock switch control (you need to unplug the button to the OFF position before starting it). -ON: key lock -OFF: Unlock
  2. Volume -/ Volume +: The volume control switch can adjust the volume under the playing state.
  3. Earphone hole: Earphone jack.
  4. USB 5V: power input
  5. Reset hole: Short press to shutdown

Charging Instructions

Check if the supply voltage on the power adapter type board corresponds to the local power supply.

  1. Plug the power adapter cable into the >>USB 5V<< socket.HOTT CD903TF CD Player - Charging Instructions
  2. Plug the power adapter into the power socket.
    – The red indicator lights up when charging. The blue indicator lights up when fully charged.
    It can be fully charged in 3-4 hours.
    – If >>display<< flashes on the display, it means that the CD player is about to run out of power.

Specification

Power input: USB —-5V 1A
Support disc format: Original CD disc, MP3 disc, CD-R, CD-RW ;
Support music formats: CD-DA, MP3, WMA
Charge Time: 3-4 hours
Play Time:>10 hours
Overall Dimension: ∮142X28mm
Bluetooth range: 10 m

Hearing
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC ID: YB2-CD903

Safety Caution

Be careful when setting the volume to prevent excessive output power from damaging your hearing.
Avoid system contact with moisture, rain, sand or all kinds of heat sources, and do not place vases or other liquid containers on the equipment.
When cleaning, please use a slightly damp soft cloth to clean the device, and never use alcohol or benzene solvent to clean it.
Please turn off the main power switch of the equipment when not in use for a long time.
Do not repair the equipment by yourself. The user will be responsible for the damage to the equipment caused by self-repair.

HOTT CD903TF CD Player - warning

Matters Need Attention

In order to use the player correctly, please read it carefully and comply with it.
Do not severely hit the host.
Do not contact benzene, diluent, and other chemicals.
Please keep away from strong magnetic and electric fields.
Avoid direct light or heaters.
Never heat or throw the battery into fire
Do not disassemble, repair or transform by yourself.
Do not use the player and earphones when riding a bicycle, driving a car, or a motorcycle to avoid danger.
Do not listen at a high volume to avoid harmful effects on hearing.
Please sort and dispose of waste packaging, batteries, and old electronic products properly.
Important tip:
A cracked disc may cause the player failure, please do not use it. If there are serious scratches, fingerprints, and dirt on the signal surface of the optical disc, it may cause equipment failure or shorten the service life of the laser head to read the disc.

Service Team:
Email: info@hottaudio.com

Documents / Resources

PDF thumbnailCD903TF CD Player
User Manual · CD903TF, CD Player

References

Questions and answers

Helpful product questions tied to this manual. Each item links to the full Q&A page.

Browse all questions about this manual

Questions & Answers

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

  1. I’ve been unsuccessful in pairing this with my Sony WH-1000XM4 Bluetooth wireless headphones. Instructions say it could take between 15-50 seconds, but I’ve waited much longer than that to no avail. Any suggestions?

    Daniel asks I've been unsuccessful in pairing this with my Sony WH-1000XM4 Bluetooth wireless headphones. Instructions say it could take between 15-50 seconds, but I've waited much longer than that to no avail. Any suggestions?
    Manuals+ clarified question
    Question

    How do I pair my Sony WH-1000XM4 Bluetooth headphones with the HOTT CD903TF CD player?

    Answer

    To pair your Bluetooth headphones with the HOTT CD903TF, please follow these steps based on the manual:

    • Enter Pairing Mode on the CD Player: While a disc is playing, long-press the M/Bluetooth icon button. The Bluetooth icon on the display should begin to flash, indicating it is in pairing mode.
    • Prepare your Sony Headphones: Ensure your Sony WH-1000XM4 headphones are in pairing mode (usually by holding the power button until you hear "Pairing" or see the indicator light flash rapidly).
    • Wait for Connection: The CD player is designed to automatically search and connect to nearby open Bluetooth devices within approximately 50 seconds.

    Troubleshooting Suggestions:

    • Check for Interference: Ensure the CD player is not in FM transmission mode, as the manual states Bluetooth and FM cannot run at the same time.
    • Distance: Keep the headphones within the 10-meter (33 feet) Bluetooth range during the pairing process.
    • Reset: If pairing continues to fail, you can try a short press on the RESET hole (located on the back/side of the unit) to shut down and restart the device.
    • Clear Other Connections: Ensure your Sony headphones are not currently connected to another device (like your phone), as this can prevent them from being "open" for the CD player to find.

    If these steps do not work, you may contact the HOTT service team at info@hottaudio.com.

  2. worked well for 4 months. now cannot get FM function to change frequency.
    radio station cuts into the cd music playing.

    Laurel S Kaiser asks worked well for 4 months. now cannot get FM function to change frequency.
    radio station cuts into the cd music playing.
    Manuals+ clarified question
    Question

    How do I troubleshoot the FM transmitter function on the HOTT CD903TF when it is stuck on a frequency or interfering with CD playback?

    Answer

    Based on the HOTT CD903TF manual, it appears your device is currently in FM transmission mode, which is used to broadcast the CD audio to a nearby radio (such as a car stereo). If you are hearing a radio station "cutting in," it is likely because the transmitter is set to a frequency already occupied by a local broadcast station.

    To resolve this, please try the following steps:

    • To Exit FM Mode: While in the playing state, long press the FM/Bluetooth key (the icon with the signal/Bluetooth symbol). This should exit the FM transmission state and return you to the normal song playing interface, which should stop the radio interference.
    • To Change Frequency: If you intend to use the FM transmitter but need to change the frequency to a clear station, enter the FM state by long-pressing the FM key. Once the frequency is displayed, short press the Prev (<<) or Next (>>) buttons to adjust the frequency band (range: 87.5MHz - 108.0MHz).
    • Reset the Device: If the buttons are unresponsive, ensure the HOLD switch on the back is in the OFF position. If it still fails to change, you can use a small pin to short-press the Reset hole located on the side/back of the unit to perform a hard shutdown.

    Note: Bluetooth and FM functions cannot run at the same time. Ensure Bluetooth is off if you are attempting to use FM features.

  3. I have a CD903TF. It quits stopping in the middle of a song. I am very unhappy with the device.

    William Case asks I have a CD903TF. It quits stopping in the middle of a song. I am very unhappy with the device.
    Manuals+ clarified question
    Question

    Why does my HOTT CD903TF CD player stop in the middle of a song?

    Answer

    Based on the HOTT CD903TF User Manual, there are several factors that can cause the player to stop unexpectedly during playback:

    • Disc Condition: The manual notes that a cracked disc, or one with serious scratches, fingerprints, or dirt on the signal surface, can cause equipment failure or prevent the laser head from reading the disc properly. Try cleaning your CD with a soft cloth or testing with a different, undamaged disc.
    • Power Levels: If the battery icon flashes on the display, the device is running out of power. Ensure the device is fully charged (takes approximately 3-4 hours) or connected to a stable USB 5V power source.
    • Reset the Device: If the player is malfunctioning, you can use the Reset hole located on the back of the device. Short-press this to shut down and reset the system.
    • Environmental Factors: Ensure the device is kept away from strong magnetic fields, moisture, or extreme heat, as these can interfere with operation.

    If the issue persists despite checking these items, you may contact the HOTT Service Team at info@hottaudio.com for further support.

    Note: The user mentioned the device "quits stopping," which may be a typo for "keeps stopping" or "quits/stops" mid-song; the troubleshooting above addresses playback interruptions.

  4. Can’t pair with my Beats headphones. Pairs with my Samsung phone fine.

    Jeri Hoover asks Can't pair with my Beats headphones. Pairs with my Samsung phone fine.
    Manuals+ clarified question
    Question

    How do I pair my Beats headphones with the HOTT CD903TF CD player via Bluetooth?

    Answer

    To pair your Beats headphones with the HOTT CD903TF, please follow these steps based on the manual's Bluetooth Function instructions:

    1. Enter Pairing Mode on Headphones: Ensure your Beats headphones are in pairing mode and are not currently connected to another device (like your Samsung phone). Bluetooth transmitters like this CD player typically connect to the first available open signal.
    2. Activate Bluetooth on CD Player: While a CD is playing, long-press the M/Bluetooth icon button. The Bluetooth icon will flash on the display, indicating it has entered pairing mode.
    3. Wait for Connection: The player will automatically search for and attempt to connect to a nearby open Bluetooth headset within 50 seconds.
    4. Troubleshooting: If it fails to connect, long-press the Bluetooth button again to refresh the transmit function. Ensure the headphones are within the 10-meter (33 feet) range.

    Note: The CD player acts as a transmitter (sending audio to headphones), whereas your phone also acts as a transmitter. The CD player cannot pair with your phone; it can only pair with receiving devices like headphones or speakers.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.