Hoopo Protector Mounting User Guide

Hoopo Protector Mounting

Protector Mounting Guidelines

• Place & attach the label on the installation surface at the selected position.
• Drill guiding holes 1&2 with 4.8 mm ( 3/16″) bit.
•  Place the hooposense unit inside the protector in one of two optional positions;
  • A – Suitable for vertical installation surface (gps antenna points to the sky).
  • B – Suitable for horizontal installation surface (gps antenna points to the sky).
• Use 2 hexagon head drilling screws and washers.
• Screws DIN 7504K-Z.P 6.3X50 (#14×2″); Washers DIN 125A Part1 – Z.P. 8mm (5/16)
• Note: Please do not over-tight the screws.

Protector Installation Label

Position A – Suitable for vertical installation surface (gps antenna points to the sky)

Position B – Suitable for horizontal installation surface (gps antenna points to the sky)