Schlage L9000-Series Gen 2 Indicator Door Preparation Template

Diagram Description

This template illustrates the door preparation for the Schlage L9000-Series Gen 2 Indicator lock, shown for a Left Hand (LH) door.

Key Components and Dimensions:

• Strike: Located on the door jamb.
• Armor Front: The plate on the door's edge where the bolt extends.
• Outside (Indicator trim side): The exterior side of the door.
• Inside (Indicator trim side): The interior side of the door.

Door Edge Preparation Details:

• Deadbolt/Latch Hole Centers: 1.031 inches (26 mm) from the door edge.
• Auxiliary Latch Hole Center: 1.250 inches (32 mm) from the door edge.
• Indicator Trim Holes:
  • Top hole center: 0.625 inches (16 mm) from the top door edge.
  • Inside trim hole center: 0.156 inches (4 mm) from the top door edge.
  • Main trim hole center: 1.125 inches (29 mm) from the door edge.
• Main Door Prep for Lock Body: A rectangular cutout measuring 3.875 inches (99 mm) in height.
• Backset: 2.750 inches (70 mm).

Note: Dimensions are shown in parentheses () in millimeters. The drawing is not to scale.

References:

Refer to Template LG1 for case and strike dimensions and information for door wire routing. Refer to Template LG3 for door edge preparation details.

The armor front, deadbolt, auxiliary latch, and latchbolt holes are shown for dimensional purposes only. Use door edge measurements for actual door preparation.