User Manual
PRODUCT NOTICE
PRODUCT NAME
Hand LF Tool—Part No.：HW71012-SGY-330
Function Summary
The hand LF tool activates the tire pressure sensor with a low-frequency 125KHZ signal and
receives the 433.92MHZ signal from the sensor to read the sensor information.
PRODUCT SPECIFICATION
| Parameter | Specification |
| Low Frequency | 125KHz, ASK |
| High Frequency | 433.92MHz, FSK |
| CAN Frequency | 500Kbps |
| Battery Capacity | 3.7V, 2600mAh |
| Recharge Port | USB 5V, 600mA |
| Working Temperature | -20°C to 55°C |
| Storage Temperature | -40°C to 60°C |
| Product Dimension | 165mm x 80mm x 31mm |
PRODUCT APPEARANCE
FCC CERTIFICATION
Model: HW71012-SGY-330
FCC ID: 2BLDF-HW71012
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure rules as this equipment has very low levels of RF energy.
Documents / Resources
 |
Hiway HW71012-SGY-330 Multi Function Tester [pdf] User Manual 2BLDF-HW71012, HW71012-SGY-330 Multi Function Tester, HW71012-SGY-330, Multi Function Tester, Function Tester, Tester |