Installation Instructions
KB-M2-W35- _ _ , KB-R2-W35- _ _ , and KB-R3-W35- _ _ Series
Fixed Wall Mount Keyboard
Cut or Drill
1. Cut or drill mounting pattern in panel. Refer to Figure 1 for the cutout dimensions.
NOTE: +/- 0.8 mm (0.03″) tolerance on all dimensions unless otherwise noted. The provided hardware is for use with panels that have a maximum thickness of 14 mm (9/16″) if using clearance holes. Thicker panels can be used but require longer screws than those provided.
FIGURE 1 – WALL MOUNT CUTOUT PATTERN
Install the Coller
2. Install the collar from the rear using the four provided M6 screws and washers as shown. Tighten all screws until the gasket is compressed to 1/16″ to 3/32″ thick.
FIGURE 2 – SIDE VIEW OF KEYBOARD
99170A
• December 20, 2022
• International: +1 678-762-9790
• UK: +44 (0) 20 7193 2618
• © 2023 Hope Industrial Systems, Inc.
Documents / Resources
 |
HIS KB-M2-W35 Fixed Wall Mount Keyboard [pdf] Instruction Manual KB-M2-W35, KB-R2-W35, KB-R3-W35, KB-M2-W35 Fixed Wall Mount Keyboard, KB-M2-W35, Fixed Wall Mount Keyboard, Wall Mount Keyboard, Mount Keyboard, Keyboard |