Installation Instructions
Family: Atlantis | Item No. 15014, 1518,
1518XX -LED, 1518xx-LL

Start Here

Glass and Bulb Installation

1.  With a Phillips screw driver, remove flat head screw on the underside of the fixture.
2. Remove the front plate.
3. Insert the bulb into the socket.
4. Slide the glass in the glass track at the back of the fixture.
5. Once the glass is in place, re-assemble the front plate and screw.

Luminaire Mounting
(For typical ground spike mounting)

1. To prevent electrical shock, disconnect the transformer from the electrical supply before installation or service.
2. Run wire from luminaire through mounting hole in the top of the ground spike.
3. Attach luminaire to ground spike by threading to mounting hole in spike and locking it in place.
4. Place spike in desired position and insert into ground until the ange of spike is flush with g round.
5. Strip the two wire leads from the luminaire and connect to the main supply wire using the provided silicone filled wire nut.

Note: Wire is to be protected by routing in close proximity to the luminaire or fitting or next to a building structure such as a house or deck. Wiring should be buried a maximum of 6 inches (15.2 cm) in order to connect to main supply wire. The main supply wire must have its length cut off within 6 inches (15.2 cm) from a building structure, a luminaire or fitting.

REV
33000 Pin Oak Parkway
Avon Lake, OH 44012
(p)800.446.5539 / (f ) 440.653.5555
www.hinkley.com
12/31/25

Documents / Resources

HINKLEY 1518xx-LL Atlantis Large LED Path Light [pdf] Installation Guide 15014, 1518, 1518XX-LED, 1518xx-LL, 1518xx-LL Atlantis Large LED Path Light, 1518xx-LL, Atlantis Large LED Path Light, Large LED Path Light, LED Path Light, Path Light, Light

References

• User Manual