HeeWing T2 Split Flap Installation
Product Information
Specifications
- Product Name: T2 Split Flap
- Installation Manual Version: 1.0
- Materials Required: Servo, control horn, steel linkage, glue/hot melt glue
Product Usage Instructions
Section 1: Preparing the Servo and Linkage
- Prepare the servo, control horn, steel linkage, and glue/hot melt glue.
- Slot the steel linkage into the control horn.
Section 2: Attaching the Split Flap
- Apply glue to the area highlighted in Red.
- Slot the steel linkage into the opening beneath the split flap.
Section 3: Installing Control Horn and Gluing Side Walls
- Install the control horn into the provided slot, ensuring it is fully seated, and wait for the glue to dry.
- Apply glue to the side walls as shown for ease of removal when needed in the future.
Section 4: Connecting the Servo
- Slot the steel linkage into the servo horn.
- Install the servo into the provided bay.
- Connect the servo wire to the flap connector found inside Electronics Bay II. Repeat this step on the other wing.
FAQ (Frequently Asked Questions)
Q: What materials are required for the installation?
A: The materials required for installation include a servo, control horn, steel linkage, and glue/hot melt glue.
Q: Can the side walls be easily removed in the future?
A: Yes, by applying glue to the side walls as shown in the manual, they can be easily removed when needed in the future.
Documents / Resources
 |
HeeWing T2 Split Flap [pdf] Installation Guide T2 Split Flap, T2, Split Flap, Flap |