Nox Hummer Element: Elegant Wooden Mid Tower PC Case

Disassembly Instructions

Front Panel: ABS+Wood

The front panel is constructed from ABS and Wood.

Projection: [Visual representation of the front panel's projection]

Installation of Fans

The case supports various fan configurations:

• Top: Supports 3 x 120 mm fans or 2 x 140 mm fans. Also supports 120/240/360/280 mm Liquid coolers.
• Front: Supports 3 x 120 mm fans, 2 x 140 mm fans, or 2 x 160 mm fans. Also supports 120/240/360/280 mm Liquid coolers.
• Bottom: Supports 1 x 120 mm fan.
• Rear: Supports 1 x 120 mm fan or 1 x 140 mm fan. Also supports 120 mm Liquid coolers.
• Power Box: Supports 2 x 120 mm fans.

Installation of PSU

Place the power supply unit (PSU) into the designated PSU chamber and secure it using the provided PSU screws as illustrated.

[Image showing PSU installation with screw locations highlighted]

2.5" SSD and 3.5" HDD Installation

2.5" SSD Installation

Unscrew and remove the HDD bracket. Insert a 2.5" SSD into the bracket and secure it with screws.

3.5" HDD Installation

Unscrew and remove the HDD bracket. Insert the 3.5" HDD into the bracket and secure it with screws on both sides. Then, place and screw the bracket back into the chassis.

[Image showing the interior of the PC case with mounting points for SSDs and HDDs indicated]

Motherboard Installation

Fit the I/O plate into its designated slot. Place the motherboard in its correct location within the case and secure it with screws.

[Image showing the rear I/O panel and an image of a motherboard being installed with screw points]

VGA Installation

Remove the PCI card slot covers. Place the VGA card into the appropriate PCI slot on your motherboard and the corresponding chassis slot. Secure the VGA card with screws.

[Image showing the rear expansion slots of the case and an image of a graphics card being installed]

USB 3.0 Installation

Plug the USB 3.0 connector into the corresponding header on the motherboard.

[Image showing a hand plugging a USB 3.0 connector into a motherboard header]

Audio HD Installation

Plug the HD Audio connector into the corresponding header on the motherboard.

[Image showing an HD Audio connector being plugged into a motherboard header]

Motherboard Connections

Connect the front panel connectors to the motherboard as follows:

• HDD LED Connector: Plug into the motherboard as marked.
• POWER LED Connector: Plug into the motherboard as marked.
• POWER SW Connector: Plug into the motherboard as marked.

Important: Please be careful and always connect positive terminals (+) to positive and negative terminals (-) to negative.

[Image showing various front panel connectors labeled and an illustration of correct polarity for connections]

Accessories