Hatz DIY Module Kit Owner’s Manual

Hatz DIY Module Kit

FAQ

Q: How do I protect the module during assembly?

A: Ground yourself before handling the circuit board to prevent electrostatic discharge (ESD) damage. Ensure proper alignment of mechanical parts before soldering to avoid issues.

Q: What should I do if components are not aligning correctly during assembly?

A: Double-check the orientation of each component to ensure correct placement. Carefully adjust and align components before soldering to prevent any issues.

INTRODUCTION

• To assemble your new module, follow the steps provided on the next.
• Assembling your module is straightforward. While all electronic components are pre-assembled, you will need to install and secure the hardware components. It’s crucial to verify that all mechanical parts are properly aligned and placed correctly before soldering.
• Be sure to double-check the orientation of each component to ensure everything is installed correctly.
• Follow each step in order, and handle the components with care, as they are delicate high-tech electronics.
• A Note on Electrostatic Discharge (ESD):
• Electrostatic discharge (ESD) occurs when static electricity builds up and discharges, such as the small shock you might feel when touching a metal doorknob. ESD can damage sensitive electronic components. To protect your module circuitry during assembly:
• Ground yourself by touching a metal surface or a grounded object before handling the circuit board.

Product Usage Instructions

FOLLOW THIS STEPS FOR BUILDING THIS KIT

Assembly Process

1. Prepare the parts to begin the assembly process.
2. Locate the metal spacers: there are three in total—two measuring (2x11mm) and one measuring (1x10mm).
   
3. Place the spacers on the control PCB as shown in the image. Use the larger spacers (2x11mm) to connect both PCBs together, and the smaller spacer (1x11mm) as indicated in the image.
4. Join both PCBs using the female and male sockets, and solder them in place.
   
5. Check the orientation of the power connector. If everything is correct, proceed with soldering.
6. Carefully trim the pins from the soldered sockets to prevent them from touching the faders.
   
7. Trim the side leg of the fader that will be positioned next to the previously installed sockets to prevent contact and avoid a short circuit. Refer to the next image for guidance.
8. The image shows how the fader’s side leg does not touch the soldered pads.
   
9. Place the LEDs, ensuring you observe the correct polarity. The longer leg should be positioned where the “+” symbol is indicated. Install all hardware and screw the panel into place, do not solder yet.
10. Solder the hardware, except for one of the bottom legs of the sliders.
    This will make it easier to adjust them if needed.
    
11. Check if the sliders are properly aligned and ensure their legs are making contact with the PCB before continuing to solder.
12. Attach both PCBs and secure them with screws.
    You are done, refer to the user manual to learn how to use the module.
    

Note on Electrostatic Discharge (ESD)

Protect module circuitry by grounding yourself before handling the circuit board to prevent ESD damage. Touch a metal surface or grounded object before assembly.