HATTEKER RFC-588 Beard Trimmer Kit
Product Description
This adjustable comb is only used for U type knife head (middle size head which is used for beard ).
The protruding point of the cutter board is matched with the buckle position in the host machine; the motor eccentric wheel of the host motor is put into the white plastic part of the head.
As shown on the right; the host motor eccentric wheel has been placed into the nose hair cut head.
Thumb and forefinger pinch the head of nose device, and force withhold, hear “da” sound, successfully buckle.
The protruding point in the cutter board is matched with the buckle position of the host machine; the motor eccentric wheel in the host machine should be placed in the groove of the cutter board
As shown on the right, the motor eccentric in the host machine is aligned to the groove point of the cutter board. Press the cutter board with thumb to make it clasp in, you can hear “da” sound.
Safety Proper use
The hair grooming kit is exclusively designed for cutting dry/human hair. The hair grooming kit is only intended for private use and is not suitable for commercial purposes. It may only be used in indoor areas. The hair grooming kit is not suitable for artificial or animal hair. Only use the hair grooming kit as described in this instruction manual. Any other use is considered improper and may result in damage to property. The manufacturer or vendor accepts no liability for damage caused by improper or incorrect use
Safety instructions
In order to reduce the risk of injury, death, electric shock, fire, malfunction, product damage and financial loss, please read the following safety instructions carefully before using this product.
Explanation of symbols
The following symbols are used to classify and explain the level of risk, injury and financial loss. Failure to follow these symbols will result in the risk, personal injury and financial loss.
Dangerous
This signal word designates a hazard with high risk, if not avoided, may lead to death or severe injury.
Warning
This signal word designates a hazard with moderate degree of risk which may lead to death or severe injury if not avoided.
Caution
This signal word designates a hazard with low risk, if not • avoided, may result in minor injury.
Dangerous
This product has a rechargeable battery inside machine. Do not throw it into fire, contact with heat source, use or charge it in high temperature, and not expose the product to excessive heat temperature.
- Otherwise it will cause overheat, burn or explosion.
Caution
Always turn off the product and pull the mains plug out of the socket when you are cleaning the product.
- Otherwise it will cause electric shock or injury.
- Only connect the product when the mains voltage of the socket is corresponds to the nameplate specification of the mains adapter, The charger pins must be fully inserted into the socket.
- Otherwise it will result in fire, electric shock or burns.
If the product is abnormal or broken, please immediately stop using the product and pull out the charger in time.
- Otherwise it will lead to fire, electric shock or injury.
Abnormal or faulty condition
The host, charger, or power cord is distorted or unusually hot. Scorched smell appears when using the host, charge or power cord. Exceptional sound is present when the host, charger, or power cord is in use or when charging.
- Please immediately stop using the machine and contact after-sales service, to check or repair.
You may not use the product in the absence of a guardian or a person who is suffering from physical, sensory, or mental retardation, or lack of experience and knowledge, and do not use the product by the child himself / herself.
- Failure to do so may result in accidents or injuries.
Do not change the power cord yourself. If the power cord is damaged, you should discard the power cord and do not use it. –Failure to do so may result in accidents or injuries.
Do not insert the charger into a household outlet or remove it from the outlet when your hand is wet.
- Otherwise it may cause electric shock or injury.
Do not use the power charger in water or clean with water.
- Otherwise it may result in electric shock or fire because of a short circuit.
Never use the charger in the bathroom or in the shower.
- Otherwise it may result in electric shock or fire because of a short circuit.
Non-technical staff do not refit or repair the product by yourself.
- Doing so may result in fire, electric shock, or injury.
Please contact after-sales service for maintenance (replacement of batteries, etc.).
Do not give the product to children or store in the place where children can touch, Do not allow children or toddler to use it by themselves.
- Put the cleaning brush into the mouth may lead to accidents and injuries.
Do not disassemble the product by yourself, except when it is discarded.
- Otherwise it will result in fire, electric shock, or injury.
Note
When Lt.Note not charging, remove the charger from the home power outlet.
- Otherwise it may cause electric leakage due to insulation deterioration, resulting in electric shock or fire.
Before using, please check whether the hair trimmer cutting hand is broken.
- Deformation of the hair trimmer cutting hand may cause skin irritation and can not be use
0verview
- Hair trimmer attachment
- Slide switch for precision trimmer cutting length fine tuning 1: 0.8 mm /2: 1.3 mm / 3: 1.8 mm
- On/off switch
- LED display:
OO/OS/l0/l5/ … /90MIN Battery capacity display Lock symbol: shows the transport lock - Beard trimmer attachment
- Precision trimmer attachment
- Body groomer attachment
- Nose/ear hair trimmer attachment
- Charging station
- Comb attachment for the hair trimmer attachment 3mm;6mm;9mm;12mm;15mm
- Precision comb 1/2/3/ .. ./9/l0mm for Beard trimmer attachment
- USB adapter
- Cleaning brush
- Storage pouch
- Comb
Charging
NOTES
Please charge the hair trimmer for approx 90minutes before the first used and during the next every time. When the battery is fully charged, the device can be used for approximately 90 minutes without being connected to the power supply.
- Switch off the device with the on/off switch if necessary.
- Connect the plug-in power unit to the socket on the device.
- Insert the plug-in power unit into an easily accessible wall socket, the voltage of which corresponds to the rating plate.
- The capacity/charging of the battery is displayed in percent
Setting up the charging station
NOTICE!
Risk of damage!
If you do not set up the charging station properly, the charging station, along with the hair grooming kit, may fall over and be damaged as a result.
- Place the charging station on a level, dry and non-slip surface.
- Connect the device plug with the charging station.
- Insert the power supply unit in a socket that is easily accessible.
Operation
CAUTION! Risk of injury!
Using the comb attachment for hair trimmer attachment
- The length of the cut may vary depending on the trimming angle.
- Begin with a comb attachment for a longer cutting length and then use progressively shorter cutting lengths as you progress with the haircut.
- To remove and change the trimmer attachments, use your thumbs to push the attachment back and off the hair trimmer.
- To mount an attachment, run the bottom clip of the attachment into the rail in the hair trimmer.
- Push the top part of the attachment on the hair trimmer until it audibly locks into place and is secure.
- Please always press the lock of release button to insert or release the comb attachment according to below images.
Changing the comb attachments
Pushing on
- To attach the comb attachments carefully slide the appropriate comb attachment over the hair or beard trimmer attachment. Press the lower part of the comb attachments firmly until they lock into place.
Removing
- To remove the comb attachments loosen the comb attachment at its lower end and pull it off the hair and beard trimmer.
- Slide the comb attachment for the beard trimmer attachment upwards from the hair and beard trimmer.
Hair trimmer attachment
- Select suitable comb attachment (3mm/9mmm/6mm/12mm/15mm ) that fits the hair trimmer attachment.
- Thoroughly comb your hair.
- Wrap a cloth or gown around your throat and neck to prevent hair clippings from falling down your collar.
- Begin the haircut with the hair trimmer attachment on the neck or the sides and cut towards the middle of the head. Then cut the front part of the hair towards the middle of the head.
- Hold the hair trimmer so that the comb attachment is flat on the head. Then run it evenly through your hair.
- If possible, trim the hair against the direction of growth.
- To ensure that you trim all hairs, run the hair trimmer over the same area of hair several times.
- If the comb attachment is not mounted, use the hair trimmer only with the hair trimmer attachment for a very short cut.
- Comb your hair thoroughly again and again.
Beard trimmer attachment
You can use the Precision comb ( 1/2/3/ .. ./9/l0mm) for the beard trimmer attachment. This adjustable comb is only used for beard trimmer attachment (middle size knife head which is used for beard).
- Comb the beard in the direction of growth.
- Cut the beard downwards from the ear to the chin. First trim one and then the other side.
- Use the beard trimmer attachment without the comb attachment to trim the beard very short or the moustache and contours. The cutting edge of the beard trimmer attachment is pointed towards the beard at a right angle.
- Push the comb attachment so that the desired cut length locks into place under the arrow mark.
- Place the comb attachment with the rounded side up against the bear and, from below, cut upwards against the direction of beard growth.
- To cut your moustache, first comb it straight down. Then use either the beard trimmer attachment or the precision trimmer attachment. Start in the middle above your mouth; cut one side and then the other.
Precision trimmer attachment
- Use the precision trimmer attachment to shorten and shape your moustache, whiskers or sideburns.
- Position the edge of the attachment at the desired height of the hair line and move the hair trimmer down.
- Using the switch for cutting length fine tuning the cutting length can be slightly varied with three levels (.l: 0.8 mm / 2: 1.3 mm / 3: 1.8 mm).
Body groomer attachment
Using the body groomer you can shave the bikini area and under arms in a more delicate way.
Proceed as indicated below to use the unit as a body groomer:
- Insert the body groomer head in place until it clicks.
- Turn on the unit by pressing the switch button.
- Place the device vertically on the skin, move the appliance against the direction of the hair growth gently and slowly.
Nose/ear hair trimmer attachment
- Slowly run the metal tip of the nose/ear hair trimmer attachment into a nostril or ear.
- Slowly move the hair trimmer in circles to cut the hair.
Transport lock
If the transport lock is activated, the lock symbol flashes.
- Press and hold the on/off switch for approx. 6 seconds, in order to switch the transport lock on/off.
- Connecting the power unit deactivates the transport lock, which cannot be activated during mains operation.
Cleaning and Care
WARNING! Risk of injury!
Always switch the hair trimmer off before cleaning.
NOTE
Clean and use the lubricating oil to improve the device after every use.
Comb attachments
- Remove the comb attachment. Rinse the comb attachment with water and let it dry before using it again.
Hair trimmer
Hair trimmer waterproof.
You can clean the hair trimmer by water.
Remove the hair remnants from the attachment using the cleaning brush included in the delivery.
Apply a few drops of blade oil to the cutting edge of the attachment. Using a soft cloth, wipe off the surplus oil, if necessary.
- Only use acid-free oil, such as e.g. sewing machine oil.
Technical data
- Model: RFC-588
- Battery charging time: 90 minutes
- Running time: 90 minutes
- Battery: lx Li-ion 14500-800 DC 3. 7v
- USB adapter:AC100-240V; DC SV l000mA
- Protection class for GS BS and UL adapter: II
Environmental treatment
The machine includes lithium battery in it. If there are some places to recycle lithium batteries in your country, make sure to discard the batteries into these places.
AMZLAB GmbH
Laubenhof 23, 45326 Essen
Manufacturer: YIWU KEHAN ELECTRICAL APPLI ANCE CO.,LTD. Address: 1-1603,Jinqiao Renjia,Niansanli Street,Yiwu City,
Zhejiang P.R.C.
Frequently Asked Questions
Is A Hatteker water resistant?
Hatteker IPX7 Waterproof Cordless Barber Clipper for Hair Cutting Kit with T-Blade Trimmer Beard Trimmer Kids Clipper Professional USB Rechargeable Hair Clipper for Men.
How should a Hatteker trimmer be cleaned?
This shaver is easy to clean and maintain because you can rinse it directly under the tap. Rechargeable – After 1.5 hours of charging, our electric shaver has a built-in battery that provides 45 minutes of cordless shaving.
How do you get a Hatteker trimmer unlocked?
Simply hold down the power button for 4-5 seconds to enter travel lock mode, and the blue lock button will appear in the bottom right corner. Hold the power button for another 4-5 seconds to remove the travel lock. The trimming machine will resume normal operation.
Is it possible to use a trimmer without an attachment?
Consider using a trimmer without a comb to trim close to the skin; avoid using the trimmer head on sensitive areas, such as the pubic region, without a comb attachment. You can use your groomer to trim and shave the hair on your body below the neckline, such as your armpits, chest, and pubic area.
Is it okay to clean a trimmer?
Cleaning clippers or trimmers is similar, but DeAngelis recommends using a spray cleaner rather than getting your clippers or trimmers wet. Brush off the blades as you would with an electric razor, then spritz with a spray cleaner, let dry, and finish with a drop of oil.
Where do Hatteker hair clippers come from?
The Hatteker trimmer is made in China, which is a bad sign. There are also some negative reviews indicating that the device would not turn on at first for a couple of buyers.
Can a beard trimmer be used to cut hair?
Trimmers are designed to work on the finer details of the beard, face, and body by cutting closer to the skin. Aside from trimming the beard, trimmers can also be used for detailing and trimming hair on the face (such as sideburns). Trimmers can also be used to remove unwanted body hair.
How long can the battery be charged?
It depends on how frequently you use it and the thickness of your hair. The battery should last at least two weeks if used every day.
How long does it take to charge the battery?
It takes about 1 hour and 15 minutes to charge the battery.
Does this kit come with a charger?
Yes, it comes with a charging stand and power adapter.
Can I use this on my head as well?
Yes, you can use it on your head as well. We recommend that you use the longest comb for your head. The longest comb is about 6 inches long and should work well for most people’s heads.
