Harmony HTT-13 True Wireless Stereo
Product Specifications
- Model: HTT-13
- Wireless Technology: True Wireless Stereo
- Charging Port: Type-C
- Features: Touch Control, Ambient Noise Cancellation Mic
- Bluetooth Version: Compatible with Bluetooth-enabled devices
- Range: Up to 10 meters
Package Contents
Product Overview
Touch Control Diagram
The touch area (MFB Touch Panel) is located in the upper part of the earbuds’ handle.
Wearing Earbuds
Note: The left earbud marked with L is worn in the left ear, and the right earbud marked with R is worn in the right ear.
INSTALLATION INSTRUCTION
Power ON/ OFF
Power on
- Auto: Open the charging case and take out the earbuds to power on
- Manually: Press and hold the MFB for 3s.
Power off
Auto: Place both earbuds in your charging case, close the lid. Manually: Press and hold the MFB for 5s.
Pairing
- Open the charging case, and take out the earbuds. The earbuds will pair automatically. One of the earbuds flashes blue and red, the other earbud goes out.
- Activate Bluetooth on the device, turn on Bluetooth, and search for pairing name “HTT-13 ” and click on it.
Tips: Next use, open the charging case, earbuds auto-connect phone.
Single Mode
When on dual mode, put one earbud into the charging case. Only take one earbud out of the charging case and connect it.
Bluetooth Lost
- Turn off the mobile phone’s Bluetooth, earbuds will enter the pairing mode and can pair with other devices.
- If the connection range is exceeded, the earbuds will enter the back connection mode. No connection within 5 minutes, the earbuds will turn off
Notes for Signal Transmission Distance (as illustrated)
Reset
If your earbuds accidentally only get one earbud to work, or fail to pair, please reset the earphones.
- Delete all Bluetooth records on the phone, and turn off Bluetooth
- Put earbuds into the charging case, and then take them out to pairing mode, tap L & R MFB 5 times simultaneously, hear “DU” prompt voice to clear all pairings.
- Put the earbuds in to the charging case.
Touch Operation
Left Earbud
Right Earbud
Earbuds low battery alarm
When the battery power is low, every 1 minute voice reminder “Lower battery” and the Red light double flashing, until the battery power runs out and turn off.
Charge your earbuds
Place your earbuds in the charging case and close the lid; the earbuds will automatically complete charging.
Product Parameter
Earbuds Warning
- Please do not place the product in an environment where the temperature is too low(above 45℃ or below 0℃).
- Do not dismantle or repair the earbuds under any circumstances. If necessary, please send the product to the seller for repair.
- Do not throw or drop the earbuds to avoid damage.
- The earbuds and the BT devices will be disconnected if the distance between them is more than 10 meters.
- Keep the device and accessories away from children and pets.
- Do not put the earbuds into the washing machine
Battery Warning
- The battery in the product may cause a fire disaster or risk of chemical burning if mishandled.
- Please charge with a rated voltage charger.
- The discard of batteries should obey local law, if possible, please recycle it. Do not dispose it as household garbage, because it may cause an explosion.
- Users are not allowed to take out or replace the battery in the product unless there is a stipulation on the user manual. It is very hazardous to do this, which may cause damage to the product.
FCC STATEMENT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC ID: 2BONF-HTT-13
FAQ
Q: How do I know when the earbuds are low on battery?
A: When the battery power is low, you will hear a voice reminder every minute along with a red light flashing until the battery Power is completely drained.
Documents / Resources
 |
Harmony HTT-13 True Wireless Stereo [pdf] User Manual HTT-13 True Wireless Stereo, HTT-13, True Wireless Stereo, Wireless Stereo, Stereo |