Happybuy Multi Function Shower Panel Instructions

Happybuy Multi Function Shower Panel

TO GET STARTED

• Before you begin, read all instructions carefully. This manual is a graphic reference for installation purposes. Some graphic elements and components may differ.
• Inspect the unit carefully to ensure there is no damage or defects. If such is the case, please contact us freely.
• Make sure you have received all parts (tools not included).
• Consult local building codes to ensure that installation complies with standards in your area.

WE STRONGLY SUGGEST YOU LET A SPECIALIST PROCEED WITH THE INSTALLATION

TECHNICAL DATA

• Operating pressure: Max.1 MPa
• Recommended operating pressure: 0.22-0.5MPa
• Test pressure: 1.5MPa (1MPa=10bar=147 PSI)
• Hot water temperature: Max.176″F
• Recommended hot water temperature: 149″F
• Connections (cold right-hot left): G1/2

RECOMMENDED TOOLS FOR INSTALLATION

PARTS LIST

• A Gasket*2 Pcs
• B Screws*4 Pcs
• C Screwanchor*4 Pcs
• D Hose clamp* 2 Pcs
• E Screws*5 Pcs
  (Rain panel & Shower panel screws)
• F Mounting brackets*2 Pcs

INSTALLATION

1. STEP1: Rain shower and Body shower panel connect
2. STEP 2: Hand-held shower holder installation.
3. STEP3: Measurement
   • Adjust the plumbing to ensure that there is adequate space for the shower to be installed.
   • Establish the precise height and position of the unit on the wall.
   • We recommend leaving a 10″(25 cm) space between the shower head and the average height of the people in the house as well as a minimum distance of 1″(2.5 cm) from the ceiling.
   • Measure the total height A from the floor to the bottom of the shower panel,
   • Measure the distance C between the lower bracket and the bottom of the shower panel,
   • Measure the distance B between the 2 brackets, Ill Project this measurement onto the wall to install the mounting brackets.
     Mark the position of each screw hole of both mounting brackets on the wall using a pencil.
4. STEP4: Mounting Brackets Installation
5. STEP5: Water supply checking and supply hoses connection
6. STEP6: Hand shower connection
7. 
8. STEP7: Test
   • No water leakage at any connection;
   • All shower modes work well.

CARE AND MAINTENANCE

• Wipe with a soft towel after each use. Use mild dishwashing detergent to keep surfaces bright and clean. Rinse well and dry with a clean cloth.
• Powdered detergents and abrasive liquid cleaners may damage surfaces.
• Do not allow the surface to come into contact with corrosive products such as acetone, nail polish remover, dry cleaning solution, lacquer, paint thinner, gasoline, or etc.
• Any cleaning product should be tested on an inconspicuous surface before using to clean.

MORE DESIGN

• The shower panel designs are different, the instructions just for reference for the installation and usage.
• The Specific operations are subject to the actual shower panel.