HALOT X1 3D Printer
Component Introduction
List of Accessories
Quick Start Operation Schematic
Lift upward to remove protective corner pads and packaging materials; Remove the power cable, Quick Start Guide, and accessory tray.
First Printing
- A (pour resin into the resin vat) or
- B (let AFU manage the resin feed).
- *HALOT series resins are recommended for the first print
- *HALOT series resins are recommended for the first print
- Tap“ Print” on the home page.
- Select the pre-sliced file stored in the device
- Click “Print” to start the first print.
HALOT-X1 Networking, Access to the Cloud
In the main interface of the device, go to“ Settings” →“ System Settings” →“ Wi-Fi”, select the Wi-Fi you want to connect to, and network the device.
Install the “Creality Cloud” app on your smartphone → Register an account; In the main interface of the device, go to“ Settings” →“ System Settings” →“ Creality Cloud”, and use the Creality Cloud app to scan the code to bind the device.
Software Installation
Download the installation package from www.piocreat3d.com. Read the installation package from a random USB flash drive
Technical Specifications
FCC STATEMENT
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used following the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IC ID Requirement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Note: The UI interface is only for reference, and shall be subject to the actual UI.
FAQ
- What resins are recommended for the HALOT-X?
- We recommend using HALOT series resins for optimal printing results.
- How do I connect my HALOT-X to Wi-Fi?
- In the device’s main interface, navigate to Settings, then System Settings, and select Wi-Fi to choose your network and connect.
- Where can I find more tutorials for machine operation and maintenance?
- Please visit the PioCreat website for additional tutorials and guidance on operating and maintaining your HALOT-X printer.
Documents / Resources
 |
HALOT X1 3D Printer [pdf] User Guide 2A2DOHALOT-X1, 2A2DOHALOTX1, X1 3D Printer, X1, 3D Printer, Printer |