DRACV48 Constant Voltage LED Driver
Instruction Manual
Constant Voltage LED Driver
INSTALLATION INSTRUCTIONS
DRACV48 100W/ DRACV48 320W
Product Features:
– Independent design
– Analogue flicker-free
– Universal AC input
– Built-in active PFC function
– Primary and secondary sides come with leads
– Protections: opencircuit, shortcircuit, overload, overtemperature
– Differential mode 4kV and common mode 6kV surge immunity for DRACV48 320W
– Differential mode 4kV and common mode 4kV surge immunity for DRACV48 100W
– SELV equivalent
– Protection class I
– IP67 design
Technical Data
| Model No. | Input voltage (V) | Max. output (W) | Output voltage (V) | Output current (A) | Power factor (λ) | Efficiency full load ( %) | No-load power (W) | Ambient temperature to °C | Max. casing emperature to(°C) | Isolation | Dimensions LxVVxH (mm) | Weight (9) |
| DRACV48 100W | 100-240 | 100 | 48 | 0-2.08 | 0.95 | 88 | <0.5 | -20…+50 | 80 | SELV | 199x67x35 | 800 |
| DRACV48 320W | 100-240 | 320 | 48 | 0-6.67 | 0.95 | 93 | <0.5 | -40…+50 | 90 | SELV | 252x90x44 | 1600 |
Wiring Details
Standards
EN 61347-1
EN 61347-2-13
EN 55015
EN 61000-3-2
EN 61000-3-3
EN 61547
Important Notes
– This Control Gear is suitable for operation with Constant Voltage LED Modules.
– Ensure min/max wattage of LED Driver is adhered to, in relation to LED Module used.
– Secondary Terminals are polarity conscious eg: positive or negative.
– Do not install LED Module to live Driver.
– Do not switch Secondary feed.
– Driver non dimmable (See dimmable range)
– Drivers must be installed above Insulation.
– Drivers must be installed by a qualified electrician.
Documents / Resources
 |
HALCYON DRACV48 Constant Voltage LED Driver [pdf] Instruction Manual DRACV48 Constant Voltage LED Driver, DRACV48, Constant Voltage LED Driver, Voltage LED Driver, LED Driver, Driver |
