Halco 82993 Surface Downlight Installation Guide

Halco 82993 Surface Downlight Installation Guide

Please read carefully and save these instructions, as you may need them at a later date.

1. INSTALLATION OR ASSEMBLY INSTRUCTIONS WIRING INSTRUCTIONS THAT SPECIFY THE PROPER METHOD OF CONNECTING THE GROUNDING MEANS AND MAINTAINING POLARITY SHALL BE INCLUDED WITH THE LUMINAIRE IN A MANNER THAT WILL REQUIRE THE INSTALLER TO HANDLE THE INSTRUCTIONS DURING INSTALLATION.
2. “THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED” and “CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI Conan BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHERENTS«
3. “CONSUL TA QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR” and “CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES CONDUCTEURS DE LA DERIVATION SONT ADEQUATS”

WARNING- RISK OF FIRE OR ELECTRIC SHOCK

• DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF WIRING OR ELECTRICAL COMPONENTS DURING LAMP INSTALLATION.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR OTHER SHARP OBJECTS.
• SUITABLE FOR WET LOCATIONS.
• SUITABLE FOR TYPE IC OR SUITABLE FOR TYPE NON-IC.
• THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS.

ASSEMBLY AND INSTALLATION

This IC/AT fixture is intended for use in suspended ceilings (with or without insulation).

1. Shut off the power before installation.
2. Fix the bracket to the junction box with screws.
3. Remove the Lens by turning it counter clockwise (FIG.1)
4. Adjust the color to desired one, by sliding the selector switch. (FIG.2)
5. Connect the wires: Black to Black, White to White, Green to Green. Secure the connection with Wire Nuts. Tuck all the wires into the Outlet box.(FIG.3)
6. Align two holes in the fixture with Outlet box. Use screws to attach one to another. Do not over tighten. (FIG.4)
7. Place the Lens back and turn it clockwise to fix.(FIG.5)
8. Complete the installation by pushing the fixtures into the ceiling. Caulk the space between the wall and the Shell. (FIG.6)

Halco Lighting Technologies 12940 Pacific Drive I Norcross, GA 30071 I Toll Free 800.677.33341 Phone 770.242.36121 Fax 800.880.08221 halcolighting.com I Atlanta I Cleveland I Houston I Los Angeles I Phoenix
© 2022 Halco Lighting Technologies, LLC. All rights reserved. Halco and ProLED are registered trademarks of Halco Lighting Technologies. All sizes and specifications are subject to change. Print Edition 041222