CEDPC350,CEDPC400 Concrete Cutter
“
Specifications:
- Model Number: CEDPC350; CEDPC400
- Manufacturer: HAHN A SYN s.r.o.
- Address: Lelkova 186/4, 747 21 Kravae, CZECH
REPUBLIC - Email: info@hahn-profi.cz
Product Usage Instructions:
1. Safety Precautions:
Before using the concrete cutter, read the user manual
thoroughly. Always wear appropriate safety gear such as goggles,
gloves, and ear protection. Ensure the work area is clear of
obstructions and bystanders.
2. Setup:
Place the concrete cutter on a stable surface. Make sure the
blade is securely attached and in good condition. Check the fuel
and oil levels before starting the machine.
3. Starting the Concrete Cutter:
Follow the manufacturer’s instructions for starting the machine.
Typically, you will need to prime the engine, set the choke, and
pull the starter cord gently until the engine starts.
4. Cutting Concrete:
Position the cutter on the concrete surface you wish to cut.
Slowly engage the blade into the concrete while applying gentle
pressure. Move the cutter in a controlled manner to create a clean
cut.
5. Maintenance:
Regularly clean the cutter after each use. Check and tighten any
loose bolts or screws. Keep the blade sharp and replace it when
necessary. Refer to the user manual for specific maintenance
tasks.
Frequently Asked Questions (FAQ):
Q: Where can I find the model and serial number of the concrete
cutter?
A: Both the model number and serial number can be found on the
main label of the machine.
Q: How do I start the concrete cutter?
A: Follow the manufacturer’s instructions for starting the
machine, which typically involves priming the engine, setting the
choke, and pulling the starter cord gently.
Q: What safety precautions should I take when using the
concrete cutter?
A: Always wear appropriate safety gear, ensure the work area is
clear, and keep bystanders away from the cutting area.
“`
Please keep this manual for future reference.
HAHN A SYN s.r.o. Lelkova 186/4 747 21 Kravae CZECH REPUBLIC info@hahn-profi.cz
Original user manual
Hahn & Sohn GmbH Janahof 53 93413 Cham Deutschland hahn@hahn-sohn.de
USER’S MANUAL
CONCRETE CUTTER
MODEL NUMBER:
CEDPC350; CEDPC400
SERIAL NUMBER:
Both the model number and serial number can be found on the main label. Please keep both numbers and keep them in a safe place for later use.
23 23 24 24 26
27
5 28
6
28
8 9 9
10 10
11 11 11 11 11 11 11 12 12 12
13 13 14 14
15 15 20
21 21 22
5
2
6
3
1
4
1
5
6
0
7
1
8
2
9
3
4
1
5
2
6
3
7
4
2
5
6
7
.
CEDPC350
CEDPC400
Original
8
9
w
a
10
T 11
12
W 3
4
We 5
1
17
1
19
2
1
2
P 3
t 4
3± 5
26
27
3± 54
13
CEDPC350
..
CEDPC400
98
12
45
25
64
5
5
19
8
22
28
Documents / Resources
 |
HAHN AND SOHN CEDPC350,CEDPC400 Concrete Cutter [pdf] User Manual CEDPC350, CEDPC400, CEDPC350 CEDPC400 Concrete Cutter, CEDPC350 CEDPC400, Concrete Cutter, Cutter |