hager NC410A Automatic Switch
Technical characteristics
Electric current
- Rated current 10 A
Architecture
- Type of pole 4P
- Curve C
Capacity
- Number of modules 4
Installation, mounting
- Nominal tightening torque top terminal 2.80 – 2.80 Nm
- Nominal tightening torque down terminal 2.80 – 2.80 Nm
- Nominal tightening torque 2.80 – 2.80 Nm
- Type of bottom connection for modular devices biconnect
- Type of top connection for modular devices Screw terminal 360° mounting position possible Yes
Main electrical attributes
Rated short-circuit breaking capacity Icn AC according to IEC 60898-1 10 kA
Voltage
- Rated operational voltage Ue 230 – 400 V
- Type voltage supply AC
- Rated insulation voltage Ui 500 V
- Rated impulse withstand voltage Uimp 4,000 V
Frequency
- Frequency 50 – 60 Hz
Safety
- Ingress Protection (IP) class IP20
Use conditions
- Degree of pollution according to IEC 60664 /
- IEC 60947-2 2
- Class of energy limitation I²t 3
- Air humidity protection For all climates
- Operating temperature -25 – 70 °C
Power
Total power loss under IN 7.90 W
Connectivity
- Type of connection Screw terminal
- Top connection alignment for modular devices Aligned terminal
- Down connection alignment for modular devices Aligned terminal
Dimensions
- Height 83 mm
- Width 70 mm
- Depth 70 mm
Connection
- Cross-section of input and output with screws, for massive conductors 1 – 35 mm²
- Cross-section of input and output with screws, for flexible conductors 1 – 25 mm²
- Cross-section of input with screws, for
- flexible conductors 1 – 25 mm²
- Cross-section of input with screws, for massive conductors 1 – 35 mm²
- Cross-section flexible conductor 1 – 25 mm²
- Cross-section rigid conductor 1 – 35 mm²
FAQ
- Q: What is the maximum short-circuit breaking capacity of the NC410A MCB?
A: The NC410A MCB has a rated short-circuit breaking capacity of 10 kA according to IEC 60898-1 standards. - Q: What is the voltage supply range for the NC410A MCB?
A: The NC410A MCB is rated for an operational voltage range of 230 – 400 V AC.
Documents / Resources
 | NC410A Automatic Switch |
References
- User Manualmanual.tools
Published: June 30, 2025
Cuáles son las salidas 5 y 6?
What are outputs 5 and 6 on the Hager NC410A?
The Hager NC410A is a 4-pole (4P) Miniature Circuit Breaker (MCB). In standard 4-pole electrical components, terminals are typically numbered in pairs from left to right.
For a 4-pole device like the NC410A:
Therefore, terminal 5 is the input for the third pole, and terminal 6 is the corresponding output for that same third pole. Please note that the provided technical data sheet confirms this is a 4-module, 4-pole device, but it does not explicitly provide a wiring diagram. Always verify the terminal markings printed directly on the front or side of the physical unit before installation.
Read the full Q&A page