LM-RC Remote Control
Product Information
Specifications:
- Remote Control Type: Four-button
- Signal Buttons: A, B, C, D
- Wireless Signal Transmission: Yes
- Power Indicator Light: Yes
Product Usage Instructions:
- Turning On the Remote Control:
- Sending Wireless Signals:
- Repeating Actions:
- Troubleshooting Tips:
Press any of the buttons (A, B, C, D) on the remote control. The
power indicator light will turn on, indicating that the remote is
active.
While holding down any button on the remote, it will emit a
corresponding wireless signal. Release the button to stop the
signal transmission.
To repeat the signal transmission action, simply press any
button on the remote control again.
- Ensure there is sufficient separation between the remote
control and the receiver for optimal signal transmission. - Plug the equipment into a power outlet on a different circuit
than the receiver to avoid interference.
Frequently Asked Questions (FAQ):
Q: How can I change the batteries in the remote control?
A: To change the batteries, locate the battery compartment on
the back of the remote, remove the old batteries, and insert new
ones following the polarity markings.
Q: Can I program the remote control to work with multiple
devices?
A: This remote control is pre-programmed and does not support
programming for multiple devices.
Q: What should I do if the power indicator light does not turn
on?
A: Check the batteries in the remote control and replace them if
necessary. If the issue persists, contact customer support for
further assistance.
User’s manual
This is a four Remote control with four signal buttons: A, B, C, D. As long as any button is pressed, the power indicator light will turn on, and the remote control will emit a corresponding data wireless signal. The remote control will continue until released, and then press any button to repeat the above actions.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help. Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-located or conjunction with any other antenna or transmitter.
Documents / Resources
 |
Guangdong LM-RC Remote Control [pdf] User Manual 2BG6G-LM-RC, 2BG6GLMRC, LM-RC Remote Control, LM-RC, Remote Control, Control, Remote |