GROW 62061 Sofa Unit Instruction Manual

GROW 62061 Sofa Unit Instruction Manual

Package Content

Assembly instructions

1. Open the zipper and remove the compressed inner cushion.
   
2. Open the compressed inner cushion at the flat end of the film. Be careful not to cut into the inner bag. The inner cushion will expand immediately.
   Remove the inner cushion.
   
3. Place the inner cushion on the floor.
   Beat the large area of the inner cushion with your hand from the centre outwards for 20 seconds at a time
   
4. Repeat the process on all sides so that the corners are well filled and a largely homogeneous surface has been created.
   
5. Remove the outer cover and open all zips.
   
6. The various chambers to be filled inside the outer cover are now clearly visible.
   
7. Slide the inner cushion marked 1 into the chamber of the seat surface”
   
8. Close the first chamber.
   
9. Slide the inner cushion marked 2 into the backrest chamber
   
10. Close the second chamber.
    
11. Close the bottom of the sofa module.
    
12. Place the sofa module in an upright position and allow it to rest for 48 hours. Only then is the final hardness achieved.
    

Care Instructions

Simply rub off loose dust.
Remove stains with a damp cloth with cold or lukewarm water, not warmer than 38°C (100 F).
We recommend using a soft cloth for cleaning.
Damp spots should be removed / dried with a dry cloth.
Only dry the GROW seaters outside in the air. Never use excessive heat on the fabric.

GROW Protection Cover (not included in delivery / available separately)
To make sure you can enjoy you GROW Outdoor furniture for a long time, we recommend you protect them with our GROW Protection Covers. They are breathable and water repellent.

Recommendation: Put the inner cushions into the outer cover after approx. 1 hour.

blomus GmbH | Zur Hubertushalle 4 | 59846 Sundern | Germany blomus.com