Great Wali W16198 Computer System User Manual

This device must accept any interference it receives, including interference that may lead to undesired operation. If you experience interference, consult the dealer or a radio/TV technician for assistance.

3. Manufacturer’s Disclaimer:

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to the equipment. Unauthorized modifications could void the user’s authority to operate the device.

Frequently Asked Questions

Q: What should I do if the device causes interference?
- A: If the device causes interference, consult a dealer or an experienced radio/TV technician for assistance in resolving the issue.
Q: Can I make modifications to the equipment?
- A: Unauthorized modifications to the equipment may cause radio or TV interference and void the user’s authority to operate the device. It is advised not to make any unauthorized modifications.

View Fullscreen

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a different circuit from
that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
69

set for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications may cause serious injury or
death.