GRAVITY COMPONENTS Remote The Eject DM Lever User Manual

GRAVITY COMPONENTS logo

User manual + assembly instructions

GRAVITY COMPONENTS Remote The Eject DM Lever

The Eject Lever DM
DM

Remote The Eject DM Lever

Step 1
Turn the M3 clamping screw out a few turns – but do not remove it completely.

GRAVITY COMPONENTS Remote The Eject DM Lever - Fig 1

Step 2
Slide the seatpost cable through the designated cable guide into The Eject Lever DM. Ensure that the washer of the previously loosened M3 screw is seated on the cable!
Tightening the M3 screw should push this washer against the cable!
Now pull the cable taut. Keep the cable taut until the M3 screw is tightened!

GRAVITY COMPONENTS Remote The Eject DM Lever - Fig 2

GRAVITY COMPONENTS Remote The Eject DM Lever - Fig 3

GRAVITY COMPONENTS Remote The Eject DM Lever - Fig 4

Documents / Resources

PDF thumbnailRemote The Eject DM Lever
User Manual · Remote The Eject DM Lever, The Eject DM Lever, Eject DM Lever

References

Published: February 10, 2026

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.

GRAVITY COMPONENTS 80384 The Leverage TNT Electric Bikes User Manual
February 10, 2026
GRAVITY COMPONENTS The Leverage MT Brake Lever Set User Manual
February 10, 2026