GLADIATOR GAWU16LSPK Light Bar Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using the Light Bar, basic safety precautions should always be followed, including the following:
Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in fire and/or serious injury.
WARNING: To reduce the risk of injury, do not stare at operating Light Bar. Serious eye injury could occur.

To avoid electrical shock, do not place the Light Bar, USB Charging Adapter, or USB Charging Cable in water or other liquid.
This product is not intended for use by children or by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge. Close supervision is necessary when the Light Bar is used near children. Always supervise children to ensure that they do not play with the Light Bar.

Disconnect and turn the Light Bar off before cleaning. To unplug the charging cable, grasp the plug end and pull from the Light Bar. Never pull from the cable.
Do not use an extension cord. Plug the USB charging adapter directly into an electric outlet.

Do not modify or attempt to repair the Light Bar or internal batteries except as indicated in the user-maintenance instructions.
Use only the provided USB charging cable. Do not attempt to charge this Light Bar with any charging adapter other than the recommended USB charging adapter.

Do not incinerate this appliance even if it is severely damaged. The batteries can explode in a fire.
Do not operate Light Bar if it is damaged or malfunctions. Return the Light Bar to the nearest Authorized Service Center for examination, repair or replacement.

Do not let charging cable hang over edge of table or counter. Never leave the Light Bar unattended while it is in operation.
Refer to the “User-Maintenance Instructions” section for instructions on cleaning the Light Bar. Recharge only with the charging adapter specified by Gladiator.

Under abusive conditions, liquid may be ejected from the Battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the Battery may cause irritation or burns.
Do not use Light Bar if it is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.

Do not expose the Light Bar to fire or excessive temperature. Exposure to fire or temperature above 265°F (130°C) may cause explosion.
Follow all charging instructions and do not charge the Light Bar outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the Light Bar and increase the risk of fire.

Use only UL Listed ITE/Class 2 USB charging adapter to charge this device. Use of any non-UL Listed USB charging adapters may create a risk of fire.
Service of Light Bar should only be performed by the manufacturer or an Authorized Service provider, using only identical replacement parts. This will ensure that the safety of the product is maintained.

Do not use Light Bar in rain or wet conditions. Do not expose to rain — store indoors.

LITHIUM-ION BATTERY OPERATED PRODUCT DISPOSAL
Always dispose of battery operated products according to federal, state and local regulations. Contact a recycling agency in your area for recycling locations.

WARNING: Do not incinerate this product even if severely damaged. The batteries can explode in a fire.

USE REQUIREMENTS

Intended for use in the garage.

Use in a dry location.

LIGHT BAR PARTS

A. Light Bar

B. Universal Mounting Bracket (UMB)
C. USB-A to USB-C Charging Cable

D. USB-A Charging Adapter (not included)

NOTE: Use a UL Listed ITE/Class 2 USB Charging Adapter rated at 2.0 A or higher for best performance.

LIGHT BAR FEATURES

A. Push Button

B. Power Button
C. USB-C Charging Input
D. LED Charge Indicator Light
E. Pull-Out Hook Used for Hanging
F. Universal Mounting Bracket (UMB)
G. Rear Mounting Magnets

OPERATING INSTRUCTIONS

GETTING STARTED

Remove and properly dispose all the packaging materials, if present.
Before first use, charge the battery until the battery status indicator turns solid green.
Use the included USB Charging Cable to charge the Light Bar, along with a Class 2 USB Charging Adapter that is a certified product (not included).
When the USB Charging Cable is connected, the charge level status will be indicated by the LED Light on the end of the Light Bar.

BATTERY STATUS WHEN CHARGING

LED	BATTERY STATUS
Solid Green	>90%
Blinking Green	30% – 90%
Blinking Yellow	15% – 30%
Blinking Red	<15%

BATTERY STATUS WHEN LIGHT BAR IS ON

LED	BATTERY STATUS
Green	30% – 100%
Yellow	15% – 30%
Red	<15%

QUICK CHARGE INFORMATION
In 10 minutes, the Light Bar will quick charge. The Light Bar will stay On for a short period with one quick charge.
IMPORTANT: Make sure to charge the battery when battery status indicator is yellow.
NOTE: The best practice is to store your Light Bar at room temperature.

BASIC OPERATION

Press the Power button to turn On the Light Bar. It will light at the brightest level on the previously set light color (refer to the section “SELECT THE LIGHT COLOR”).
Press the Power button a second time to Dim the light.

Press the Power button a third time to turn Off the Light Bar.

SELECT THE LIGHT COLOR

With the Light Bar On, hold down the Power button to initiate the light color change process.
While holding the Power button, the light color will cycle through the three available options.
Release the button when the desired light color is displayed. The light bar is now set to that color.

COLOR AND BRIGHTNESS SETTINGS

COLOR	COLOR TEMP	HIGH	LOW
Blend	4500 K	600 lm	240 lm
Soft White (Warm Light)	3000 K	300 lm	120 lm
Daylight (Cool Light)	6000 K	300 lm	120 lm

RESET THE LIGHT BAR

To reset the Light Bar back to the factory setting, hold the Power button down while the light is Off. The LED light on the side will blink three times.

Release the Power button after the three blinks and the factory setting will be restored.
Factory setting includes color temperature of 4500 K “Blend” color mode.

INSTALLATION INSTRUCTIONS

UNPACK THE LIGHT BAR

Remove and verify the contents as shown in “LIGHT BAR PARTS.”
Dispose of or recycle all packaging materials.

REMOVING THE LIGHT BAR FROM THE UMBPress down on the Push Button and pull the UMB straight out.

NOTE: Light Bar can be attached in three ways:

Universal Mounting Bracket to GearTrack® Channels or GearWall® Panels.
Universal Mounting Bracket directly to the Wall.

Using Rear Mounting Magnets on a Steel Surface.

TOOLS REQUIRED
NOTE: No tools are required if using Gladiator® GearTrack® Channels or GearWall® Panels.

MOUNTING THE UMB TO THE GEARTRACK® CHANNELS OR GEARWALL® PANELS
NOTE: Gladiator® GearTrack® channels and GearWall® panels are sold separately. For installation of the Gladiator® GearTrack® Channels and GearWall® Panels to a Wall, refer to “Instruction Manual” included with the Gladiator® GearTrack® Channels and GearWall® Panels.

Slide the UMB down into slots until it “Snaps” into place.
NOTE: Bottom tab on the Universal Mounting Bracket will be over the bottom edge of the center strip.

MOUNTING THE UMB DIRECTLY TO THE WALL

TOOLS REQUIRED
Gather the required tools before starting installation.

#2 Phillips head screwdriver (not included)
#8 Phillips head screws with threaded drywall anchors (not included)
Level (not included)

Tape measure (not included)

Make a mark on the Wall.
Measure 5 inches horizontallly and place another mark.

Place the Screws in the Wall where the marks are present, leaving them out enough to hang the UMB.
NOTE: Make sure to use a Level for the best results.

NOTE: It is recommended to use threaded anchors when mounting to drywall.

Place the UMB over the top two Screws.

Place the Screws into the two remaining holes.

ATTACHING THE LIGHT BAR TO THE UMB

Insert the UMB into the Light Bar as shown. IMPORTANT: Make sure that the rails and the grooves line up.

Press firmly until the Light Bar locks in place.

MOUNTING THE LIGHT BAR TO A STEEL SURFACE Place the Rear Mounting Magnets against Steel Surface.
NOTE: It is recommended to use a Steel Surface at least 0.5 mm thick.

MOUNTING OPTIONS

WHEN USING GLADIATOR® GEARTRACK® CHANNELS OR GEARWALL® PANELS

WHEN USING REAR FACING MAGNETS
NOTE: Magnets adhere to most flat steel surfaces.

Flat Surface of the Cabinet Down, Up, or at Any Angle

WHEN USING THE PULL-OUT HANGING HOOK
Hang the Light Bar from the Pull-Out Hanging Hook and Rotate to the Desired Direction

PRODUCT SPECIFICATIONS

CHARGING CABLE
Length	4 ft Kink/Tangle Resistant
Type	USB-A to USB-C
CHARGING
USB-A Charging Adapter (not included)	5 V/2 A NOTE: Use a UL Listed ITE/Class 2 USB Charging Adapter rated at 2.0 A or higher for best performance.
BATTERIES
Dual Battery	5200 mAh
Charging Time (Light Bar is Off)	Approx. 3 hours NOTE: Charge time extends when the Light Bar is in use.
Run Time (Full Charge)	Approx. 6 hours on low Approx. 2 hours on high (varies with color selection)
ENCLOSURE
Drop Protection	10 ft
TEMPERATURE
Operating Temperature	40°F to 100°F (4.44°C to 37.8°C)
Storage Temperature	32°F to 140°F (0°C to 60°C) NOTE: It is best to store in cool, dry, and well-ventilated area.

USER-MAINTENANCE INSTRUCTIONS

Use mild dish soap to clean surfaces.

Wipe with damp cloth.
Do not immerse in water.
Do not use abrasive cleaners.

TROUBLESHOOTING

PROBLEM	SOLUTION
If the Light Bar fails to light	Check if the Light Bar is charged. Charge the battery when the battery status indicator is red or when the battery is completely drained.
If the Light Bar is not getting charged	Replace the Charging Cable. Replace the USB adapter.
If the problem cannot be corrected	See the “Warranty” section. Do not return the Light Bar to the retailer. Retailers do not provide service.

ACCESSORIES

To order accessories, call 1-866-342-4089 and ask about available accessories, contact your authorized Gladiator® dealer or visit our website at www.gladiatorgarageworks.com
In Canada, call 1-800-807-6777 or visit our website at www.gladiatorgarageworks.ca

WARRANTY

For warranty information:
In the U.S.A. call 1-866-342-4089 or visit our website at www.gladiatorgarageworks.com
In Canada call 1-800-807-6777 or visit our website at www.gladiatorgarageworks.ca

Documents / Resources

GLADIATOR GAWU16LSPK Light Bar [pdf] Owner's Manual
GAWU16LSPK Light Bar, GAWU16LSPK, Light Bar, Bar

References

User Manual

GLADIATOR GAWU16LSPK Light Bar

LIGHT BAR SAFETY