ASSEMBLY INSTRUCTIONS

Step 1 During assembly, leave within open cardboard carton to avoid scratches. R-Wrapper frame must lay down as in the way it is carried with single ‘carriage tube’ UP as illustrated.
Step 2 Remove smaller cardboard wrap from Carriage and slide carriage right, towards pulley-end of frame.
Step 3 Remove and unwrap base and wheels from carton and keep nearby the ‘wooden shipping-board’ end.
Step 4 To remove the shipping board and while supporting the carriage tube weight: Undo two 13mm bolts with a spanner and the 6mm socket head bolt with an allen-key. Swap board with base and wheels and fasten bolts through base into frame tube ends. Tighten 6mm ‘Allen-key’ with spanner or tube for leverage. Check frame tubes are parallel before tightening 13mm bolts firmly when R-Wrapper is upright.
Step 5 Slide Carriage toward base before standing R-Wrapper up on wheels to avoid carriage dropping down to the base
Step 6 Ensure lift rope is sitting in pulleys and not snagged around pulleys, carriage or any control handles then check operation.
See INSTRUCTIONS FOR USE sheet for correct operation

STEP 1: Wheel the r-Wrapper to the pallet TO do the job!
PACKMATE R-WRAPPER, MOBILE, ERGONOMIC PALLET WRAPPING. DESIGNED & MADE IN AUSTRALIA. SEE.

CUSTOMER SERVICES

029452-3566
sales@getpacked.com.au