Generic Ring01 Smart Remote Control Ring User Manual

Generic Ring01 Smart Remote Control Ring

Overview

Ring01 is a lightweight wearable Bluetooth remote ring with a physical three-button design for music control, short video control, and remote photography.

Specifications

Setup & Use

1. Power on/off: Long-press the middle button for 6 seconds to turn the ring on or off.
2. Pair with your phone: On your phone, open Settings > Bluetooth, search for Ring01, then complete pairing.
3. Switch modes: Triple-tap the middle button to switch among the three modes (music control, short video mode, photo mode).
4. Charge: Use magnetic charging with a standard charger rated 5V/1A or above. The red light remains on during charging and turns off automatically when fully charged.

Introduction

The Ring01 smart remote control ring is a lightweight wearable Bluetooth remote control device featuring a physical three-button design, making it easy to wear without any burden.
Product support: Three core working modes, namely music control, short video manipulation, and remote photography, provide convenient control experiences for various scenarios such as commuting, exercising, indoor leisure, group photos, and selfies.

Product Functions

• Triple-tap the middle button to switch among the three modes
• TikTok Video Mode
• Music Mode
• Photo Mode

Power On & Pairing

• Power on/off
• Long-press the middle button for 6 seconds to switch the ring on or off
• Connect to mobile phone: Open your phone’s “Settings – Bluetooth”, search for the device name “Ring01”, and complete the pairing process
  Note: Touch control needs to be enabled on Apple phones
• Open the “Settings” app on your iPhone and click on “Accessibility”
• On the Accessibility page, click the [scaling] option
  Note: If the zoom is accidentally turned on and the screen is enlarged, you can restore it by tapping the screen twice with three fingers simultaneously.
  Automatic shutdown: The device will automatically shut down after 15 minutes of inactivity

Additional Information

• Charging
  This ring supports magnetic charging. Use standard chargers rated 5V/1A or above; low-quality chargers may damage the product. The red light stays on during charging. The red light turns off automatically when fully charged.

Packing List

• 1 × Smart Remote Ring
• 1 × Type-C Charging Cable
• 1 × Printed User Manual

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.