RF-17 Remote Control
Product Information
Specifications:
- Controller Type: 13-button wireless
- Signal Control: 433MHz
- Compatibility: LED lighting fixtures
- FCC Compliance: Part 15
- Radiation Exposure Limits: FCC approved
Product Usage Instructions:
1. Installation:
Place the controller within the recommended distance of 0cm
between the radiator and your body. Ensure it is easily accessible
for operation.
2. Pairing with Lighting Fixtures:
Follow the pairing instructions provided by the manufacturer of
your LED lighting fixtures to sync them with the controller. This
typically involves pressing specific buttons in a sequence.
3. Operation:
Press the appropriate buttons on the controller to turn the
lights on/off, adjust brightness, or switch between different
lighting modes as per your fixture’s capabilities.
4. Maintenance:
Keep the controller clean and free from dust or moisture.
Replace the batteries promptly when low to ensure smooth
operation.
FAQ (Frequently Asked Questions):
Q: Can this controller be used with non-LED lighting
fixtures?
A: No, this controller is specifically designed for use with LED
lighting fixtures due to its signal control compatibility.
Q: What should I do if the controller stops working?
A: Check the battery level and replace if necessary. Ensure
there are no obstructions blocking the signal between the
controller and the lighting fixtures. If issues persist, contact
customer support for further assistance.
User Manual
This 13-button controller uses 433MHz wireless signal control and is used to control various lighting fixtures with LED as the light source.
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Documents / Resources
 |
Generic RF-17 Remote Control [pdf] User Manual 2BO5W-RF-17, 2BO5WRF17, RF-17 Remote Control, RF-17, Remote Control |